FILM-IDENTIFICATION 9X1798 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Do not disconnect the air lines until the air pressure in the system is at zero. If hose is disconnected under pressure it can cause personal injury.
Loosen the purge valves, and release the air pressure in the air tank.
Illustration 1 g00620850
Typical example
Disconnect coolant supply line (1) and air supply line (2) from the air compressor.
Disconnect oil supply line (3) from the air compressor.
Illustration 2 g00620840
Typical example
Remove coolant line (4) from the air compressor.
Remove nuts (5) that hold the air compressor to the accessory drive.
Remove the air compressor from the engine.
Illustration 3 g00620856
Typical example
Remove seal (6) from the air compressor.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 4 g00620856
Typical example
Install new seal (6) on the air compressor.
Install the air compressor on the engine.
Illustration 5 g00620840
Typical example
Install nuts (5) to hold the air compressor on the engine.
Connect coolant line (4) to the air compressor.
Illustration 6 g00620850
Typical example
Connect coolant supply line (1) to the air compressor.
Connect air supply line (2) to the air compressor.
To prevent water from collecting and freezing in the air compressor lines, ensure that the air compressor lines are sloping downward and away from the air compressor.
Connect oil line (3) to the air compressor.