FILM-CATERPILLAR 9X2433 - Caterpillar

Rear Window Defroster - If equipped, press the top of the switch in order to activate the rear window defroster. Fan Speed Control (26)
Fan Speed Switch - This knob controls the three-speed blower fan motor.
Off - Move the knob to this position in order to stop the blower fan motor.
Low - Move the knob to this position for the lowest fan speed.
Medium - Move the knob to this position for a medium fan speed.
High - Move the knob to this position for the highest fan speed. Bucket/Fork Selector Control (27)
This switch selects the tilt kickout that is operational.Press the bottom of the switch in order to select the preset angle for the tilt kickout of the bucket.Press the top of the switch in order to select the preset angle for the tilt kickout of the forks.Kickout and Positioner Control (28)
Kickout Control - Push the top of the switch in order to activate the lift kickout and the tilt kickout. Push the bottom of the switch in order to deactivate the kickouts. Temperature Control Switch (29)
Temperature Control Knob - Turn the knob clockwise to COOL. Turn the knob counterclockwise to WARM. Ride Control or Load Check Switch(30)
Ride Control
If equipped, the ride control system acts as a shock absorber by dampening forces from the bucket. This helps to stabilize the entire machine.Note: Push the middle of the ride control switch (30) in order to turn off the ride control. Placing the ride control system in the OFF position allows more efficient loading of the bucket. Failure to move the switch to the recommended position could result in damage to the machine.
Automatic Ride Control - Push the top of the switch in order to turn on the automatic ride control. The ride control system will automatically turn on if the ground speed exceeds 9.6 km/h (6 mph). The ride control system will automatically turn off if the ground speed is less than 9.6 km/h (6 mph) and if the bucket is being operated.
Manual Ride Control - Push the bottom of the switch in order to turn on the manual ride control. When the ride control switch is in the manual position, the ride control system will be operational at all times.Load Check Switch
Refer to Operation and Maintenance Manual, "Equipment Lowering with Engie Stopped" for more information.Autoshift Control (31)
Manual Mode - Push the bottom of the switch for the manual mode of the autoshift function. Use transmission control (4) to select the desired speed and the desired direction in the manual mode .If equipped, the transmission direction control switch on the pilot hydraulic bucket control is only active when the transmission is in second gear. Press the downshift switch briefly while the machine is in second gear. The transmission will downshift to first gear. The transmission will remain in first gear until a speed change is made or a direction change is made.
Automatic Mode - To activate the automatic mode of the autoshift function, push the top of the switch prior to