FILTER ELEMENT AS-OIL 1328875 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5B-4274     Bolt     2    Start By:
Remove the water pumps. Refer to Disassembly and Assembly, "Water Pump - Remove" and Disassembly and Assembly, "Auxiliary Water Pump - Remove".
Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Illustration 1 g00561379
Note: The same procedure is used for removing the idler gears and the idler shafts on both sides. The idler gears on each side are different. The idler gears must be installed on the correct side in order to get the correct engagement with the crankshaft gear.
Remove the bolts that hold idler shaft (2) in place.Note: DO NOT allow the gear to fall when the idler shaft is removed.
Install Tooling (A) in idler shaft (2) .
Use your hands in order to support idler gear (1). Tighten Tooling (A) evenly. Remove idler shaft (2) from the front housing.
Remove idler gear (1) from the front housing.
Illustration 2 g00561404
Remove O-ring seals (3) from idler shaft (2) .
Illustration 3 g00561405
Note: The idler bearing in the illustration shows a groove for an internal oil supply. The new idler bearings do not have a groove for an internal oil supply.
If necessary, remove bearing (4) from idler gear (1) .
Illustration 4 g00561407
Remove thrust washer (5) from the front housing.