FILTER GP-OIL 1940593 - Caterpillar

Illustration 9 g03740787
(3) 5I-4376 Fitting
(25) 468-7013 Support As
(28) 148-8336 Connector As
(29) 148-8353 Elbow As
(35) 164-5567 Quick Disconnect Coupler As
(36) 164-6874 Elbow Fitting
(40) 6V-0852 Dust Cap
(44) 8T-4194 Bolt
(46) 8T-4223 Hard Washer
Install assembled valve groups to the machine frame above the main hydraulic pump as shown.
Install connectors and elbows to port "M1" on hydraulic pump
Illustration 10 g03740808
(9) 241-6215 Elbow As
(17) 338-6971 Pressure Sensor Gp, 64 3 N m (47 2 lb ft)
(22) 467-1480 Tube As
(27) 101-7404 Bolt
(39) 4J-5267 O-Ring Seal
(41) 6V-9746 O-Ring Seal
Install tube (22) and pressure sensor (17) to the main control valve as shown.Note: Remove existing hose group 236-3212.Note: Apply thin layer of hydraulic oil on male threads of pressure sensor (17) before installing.
Illustration 11 g03740853
(7) 168-1968 Tee As, 29 2 N m (21 1 lb ft)
(12) 285-2423 Tube As
(14) 319-4407 Pressure Switch
(26) 101-7402 Bolt
(30) 148-8363 Elbow As
(37) 169-5862 Elbow As
(38) 4J-0527 O-Ring Seal
Install tube, elbows, tee, and pressure switch.Note: Remove existing tube from the machine.
Illustration 12 g03740857
(1) 4I-9521 Marker Band (RED)
(2) 4I-9522 Marker Band (YELLOW)
(4) 7K-1181 Cable Strap
(8) 187-5954 Hose As
(16) 337-2709 Grommet
(23) 474-9622 Hose As
(24) 474-9625 Hose As
(33) 148-8415 Reducer As, 76 4 N m (56 3 lb ft)
Install hoses (8), (23), and (24).
Illustration 13 g03741019
(5) 104-8783 Hose As
Route hose (5) from tube (12) to port (T) on solenoid valve (15a).
Illustration 14 g06126554
(1) 4I-9521 Marker Band (RED)
(2) 4I-9522 Marker Band (YELLOW)
(4) 7K-1181 Cable Strap
(5) 104-8783 Hose As
(16) 337-2709 Grommet
(15a) 328-2035 Solenoid Valve and Manifold Gp
(15b) 328-2035 Solenoid Valve and Manifold Gp
(21) 466-3340 Hose As
(23) 474-9622 Hose As
(24) 474-9625 Hose As
Route hoses (5), (23), and (24) and connect to port locations as shown.Note: Some hoses removed from valves to show other hose routing.
Connect hose (21) to port "M1" on the main pump and port "P" on solenoid valve (15b).
Unless specified, tighten all fittings and hardware to standard torque.
Check for leaks.