FILTER GP-OIL 2106243 - Caterpillar

Illustration 5. Typical Shield Termination: (26) Circuit Identification Prefix "A330". (27) 2H-2965 Wire Splice. (28) 116-7648 Cable Assembly. (29) 5P-1038 Heat Shrinkable Tube. Terminal Number Identification Suffixes: (30) "T202". (31) "T203". (32) "T204".* Remove and discard terminals 205, 206, and 207.* Install three 116-5142 Double Isolated Terminals with 116-5137 Spacer and 116-5193 End Cover in place of 205, 206, and 207 along with both end plates at the bottom of the right hand column of the terminals.* Slide all right hand connectors snugly down against the bottom end block.* Remove and discard terminals 260 through 267 and the top end plate.* Replace terminal 260 through 267 with 116-5140 Double Terminal and 115-2538 End Cover.* Install 108-1702 Single Terminal 270 through 273 at the top of the right hand terminal column.* Position top 9X-9616 End Cover and bracket snugly against terminal 273.* If used, install the voltmeter gauge group at the same location as where the ammeter was previously mounted.* Remove the old E-stop contact block and switch operator. Replace it with new 109-6507 Operator Switch, 111-1323 Contact Block, and 111-1324 Contact Block. When attaching wires to each contact block care must be taken to connect each wire to its respective terminal number. Refer to Chart 5 or 121-0121 Wiring Diagram for correct wiring.15. Route the new service harness as shown on the harness drawing. Pull excess harness length tight between clips. Securely attach it with a nylon tie strap. Adjust clipping and positioning of the harness in order to allow the harness to touch only at each mounting clip and mating connector. Ideally, the harness should not be in contact with any other engine part.16. Carefully feed the harness through the opening located on the engine-mounted terminal panel bottom and firmly hand-tighten. Do not remove the nylon tie straps used to bundle the harness wires. Each wire end has been cut to length, terminated, and bundled to allow it to fall on its respective termination point without excessive stretching or slackness.17. Connect each wire end at its respective termination point by loosening each terminal screw clamping device. Insert wire end to its maximum depth. Each wire end should be held at that depth while tightening the terminal clamp. Lightly tug on each wire after clamping to determine if it is securely clamped. Each wire has been labelled with a circuit function code and termination point. As an example, the red wire labelled S111-T271 is known by the prefix "S111". It is also the MAP sensor +13 volt power; known by the suffix "T271" which is to be connected at terminal 271. All wires have been marked in this fashion. Therefore, connecting each wire by its labelled termination point can greatly facilitate the installation process. It is, however, highly recommended that wiring verification is performed. Refer to Chart 5 for a complete listing of service harness wire identifications and termination points. The exception to this rule has been noted with an asterisk (*).One faulty connection could instantly destroy not