FILTER GP-OIL 2321864 - Caterpillar

Illustration 1 g01520688
The following bolts are 215.9 mm (8.5 inch) long: 11, 12, 13, 14, 16, 18, 20, 22, 24 and 26. The following bolts are 193.0 1.0 mm (7.60 0.04 inch) long: 2, 8 and 10. The rest of the bolts are 194 mm (7.6 inch) long.Note: The flatness of the cylinder head should be within a total of 0.13 mm (0.005 inch). Also, the flatness of the cylinder head should be within a maximum of 0.05 mm (0.002 inch) for any 150 mm (6.0 inch) span.
Illustration 2 g01441122
(A) Cylinder head thickness Thickness of a new cylinder head ... 120.00 0.15 mm (4.724 0.006 inch) Minimum thickness of a used cylinder head ... 119.50 mm (4.705 inch)
Illustration 3 g01623617
(1) Sleeve bearing joint (2) Oil gallery (3) Oil holes (4) Sleeve bearing
Camshaft bearings must be installed into their correct position. Failure to do so will result in engine damage.
Illustration 4 g01623618
(B) Orientation of the sleeve bearing joint ... 20 5 degrees above horizontal (C) Bore for camshaft sleeve bearing ... 90.985 0.020 mm (3.5821 0.0008 inch)
Illustration 5 g01520165
The depth of installation of the sleeve bearings is important. Install sleeve bearings (4) to the following depths: Dimension (D) ... 8.0 0.5 mm (0.31 0.02 inch) Dimension (E) ... 178.1 0.5 mm (7.01 0.02 inch) Dimension (F) ... 349.5 0.5 mm (13.76 0.02 inch) Dimension (G) ... 521.0 0.5 mm (20.51 0.02 inch) Dimension (H) ... 692.4 0.5 mm (27.26 0.02 inch) Dimension (J) ... 863.8 0.5 mm (34.01 0.02 inch) Dimension (K) ... 1035.3 0.5 mm (40.76 0.02 inch)
Illustration 6 g01623607
(5) Before assembly, apply 4C-9506 Retaining Compound to press fit diameter of the lower end of six injector sleeves.Note: Press the injector sleeve to the bottom of the face (6) .Note: Before assembly, apply 4C-9506 Retaining Compound to the bore of the cup plugs. (V) Installation depth for the cup plugs ... 1.25 0.25 mm (0.050 0.010 inch)