FILTER ELEMENT-CAB AIR 3483432 - Caterpillar

There are three control panels that are available for the generator set. The standard control panel has mechanical gauges and an electronic control with indicators. This panel does not have a digital display.The premium control panel does not have any mechanical gauges. This panel has a digital display. The gauges are included in the electronic control and the gauges are digital. The MCS control panel does not have any mechanical gauges. This panel has a digital display. The gauges are included in the electronic control and the gauges are digital. The operation of the three control panels are described below.Standard Control Panel
Note: TYPE 1 & 2
Illustration 1 g00827470
Standard control panel (Type 1) (1) Temperature gauge (2) Oil pressure gauge (3) Control module (generator set) (4) Hour meter (5) DC voltmeter (6) Horn (7) Emergency stop push button (8) Alarm silence switch
Illustration 2 g01110643
Standard control panel (Type 2) (1) Temperature gauge (2) Oil pressure gauge (3) Control module (generator set) (4) Hour meter (5) DC voltmeter (6) Horn (7) Emergency stop button (8) Alarm silence switchTemperature Gauge (1) - The water temperature gauge (WTG) shows the engine water temperature. The engine should operate within the range of 78 °C (172 °F) to 90 °C (194 °F). The water temperature may vary according to load. However, the water temperature should never exceed the boiling temperature for the pressurized system that is being used. The water temperature is regulated by the engine thermostats in the system. Do not operate the engine if no thermostats are installed on the engine.If the engine is operating and a high water temperature reading is observed, perform the following steps:
Reduce the load.
Inspect the engine for coolant leaks.
Inspect the engine for a plugged radiator.
Determine if the engine should be shutdown.The WTG is powered whenever the engine is operating. The value which is shown on the WTG is proportional to the flow of current through the WTG. The current flow is controlled by the resistance of the water temperature sending unit (WTSU). As the water temperature changes there is a corresponding change in the resistance of the WTSU. A corresponding change is shown in the value on the WTG.Note: If the WTSU is not fully submerged because of low water level, the temperature reading will be false.Oil Pressure Gauge (2) - The oil pressure gauge (OPG) shows engine oil pressure. The oil pressure will be greatest after a cold engine is started. Oil pressure will decrease as the engine is idling. As the engine speed is increased to full load speed, oil pressure will increase and oil pressure will stabilize.Normal operating engine oil pressure should be 290 kPa (42 psi) to 448 kPa (65 psi) when the engine is running at rated engine speed. The SAE 10W-30 oil should be at 93 °C (199.4 °F) to 125 °C (257 °F) operating oil temperature. The engine water operating temperature should be normal. A lower pressure of 186 kPa (27 psi) to 344 kPa (50 psi) is normal at low idle speed.If