FILTER GP-FUEL 3584749 - Caterpillar

Illustration 18 g01284612
Install planetary shaft (25) in carrier assembly (19) and through planetary gear assembly (24). Make sure that the spring pin hole in planetary shaft (25) is in alignment with the spring pin hole in the carrier.
Illustration 19 g03142259
Orient the split in spring pin (23) as shown. Make a stake mark on each side of the spring pin hole in the carrier. This will prevent spring pin (23) from falling out of the spring pin hole. Each stake mark should be approximately to 2.25 0.75 mm (0.089 0.030 inch) from the outside diameter of the spring pin hole.
Repeat Steps 20.a through 20.e in order to install the other two planetary gear assemblies in carrier assembly (19).
Illustration 20 g01284609
Install sun gear assembly (22), spacer (21), and retaining ring (20).
Illustration 21 g01284605
Use Tooling (B) and a suitable lifting device in order to install carrier assembly (19). The weight of carrier assembly (19) is approximately 95 kg (210 lb).
Illustration 22 g01284603
Illustration 23 g01284599
Apply clean SAE 30 oil on bearing (17). Install washers (16) and bearing (17) in planetary gear (18).
Install planetary gear assembly (13), planetary shaft (15), and drive spring pin (14) into planetary shaft (15).
Repeat Steps 23 and 24 for the remaining planetary gear assemblies.
Illustration 24 g01284596
Install sun gear (12), spacer (11), and retaining ring (10).
Illustration 25 g01284593
Use Tooling (B) and a suitable lifting device in order to install carrier assembly (9). The weight of carrier assembly (9) is approximately 43 kg (95 lb).
Illustration 26 g01284589
Install sun gear (8).
Illustration 27 g01284579
Install the shims and spacer (5) in housing cover (3).
Install ring gear (7) and socket head bolts (6) in housing cover (3).
Illustration 28 g01284577
Use Tooling (B) and a suitable lifting device in order to position housing cover (3). Install bolts (4) and the washers. The weight of housing cover (3) is approximately 95 kg (210 lb).
Illustration 29 g01284563
Remove Tooling (B) and install socket setscrews (2) in housing cover (3).
Illustration 30 g01286860
Remove plug (54). Attach Tooling (M) in order to perform a pressure test on the final drive. Note: The final drive must sustain 98 kPa (14 psi) air pressure without a drop in pressure for 30 seconds. A pressure over 98 kPa (14 psi) must be avoided.
Install plug (54). Tighten plug (54) to a torque of 80 10 N m (59 7 lb ft).
Illustration 31 g01284546
Remove final drive (1) from Tooling (A). The weight of final drive (1) is approximately 1020 kg (2250 lb). End By:
Install the final drive.