FILTER GP-FUEL 4184211 - Caterpillar

When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Illustration 3 g01434979 (1) Apply Tooling (G) to the hole of ring (2) prior to installation. (2) Use Tooling (A) to remove bearing (2). (3) Refer to Table 2 for the correct torque value for the locknut or piston
Table 2
Torque Table
Thread Size Thread Lubricant Torque Specification
1– 1/8 - 12 Tooling (H) 1356 N m (1000 lb ft)
M50 x 2 Clean Hydraulic Oil 2865 287 N m (2113 212 lb ft)
M56 x 2 Clean Hydraulic Oil 3600 180 N m (2655 133 lb ft) (4) Apply Tooling (F) to the outer diameter and the inner diameter of seal (4). (5) Apply Tooling (F) to the outer diameter and the inner diameter of ring (5). (6) Apply Tooling (F) to the outer diameter and the inner diameter of ring (6). (7) Torque for head assembly ... 650 70 N m (480 50 lb ft) (8) Use Tooling (B) to remove bearing (8). (8) Apply Tooling (F) to the sealing lip of buffer seal (8). (9) Apply Tooling (F) to the sealing lip of seal (9). (10) Apply Tooling (E) to the groove of lip seal (10) prior to installation. Apply Tooling (F) to the sealing lip of lip seal (10).Installation Procedure
Table 3
Required Tools
Tool Part Number Part Description Qty
F 5P-0960 Grease Cartridge 1
Prior to installation of the bucket cylinder, make sure that the pin bores in the stick, in the link assemblies, and in the bucket cylinder are clean and free of dirt.
Illustration 4 g01434881
Attach a suitable lifting device to bucket cylinder (4). The weight of bucket cylinder (4) is approximately 135 kg (300 lb). Be sure that the pin bores in the stick and bucket cylinder are in alignment. Also, make sure that the grease fittings in the head end and in the rod end of the bucket cylinder are facing away from the stick.
Apply Tooling (F) on pin assembly (5). Temporarily install the pin assembly (5). Do not remove the suitable lifting device from the bucket cylinder at this time.
Install the shims between the stick and bucket cylinder on the side opposite the retaining bolt for the pin assembly. Install the spacer and pin assembly (5). Install the washer and retaining bolt (6).
Connect hose assemblies (7).
Illustration 5 g01434878
Illustration 6 g00357378
Lower the bucket cylinder between the link assemblies. Apply Tooling (F) on pin (2). Be sure that the bore in the bucket cylinder rod is aligned with the bores in the link assemblies. Install any shims that were present during the removal procedure. Install pin (2). Install retaining bolt (1) and the nuts.
Rotate pin (2) until