FILTER AS-FUEL 4343928 - Caterpillar

Engine: 3516B (S/N: TRE1-UP)Off-Highway Truck: CAT MT4400D (S/N: MH41-UP; TRD1-UP)Introduction
Inspections are a basic form of condition monitoring. Proactive monitoring and analysis of equipment information will allow Dealers to intervene before problems occur. Note: Before adjusting product settings to comply with listed baseline TA2 values, consult SIS for the latest specification values.Creating an Electronic Copy
Use the following procedure to create an editable electronic copy from SIS Web.
Click format to print.
Save the document as an HTML format.
Open the document with Microsoft Word.Electrical System
Table 1
Status (1)    Description    Specification    Actual    Comments    
    Inspect Battery Cables     Cables between the battery, the starter, and the engine ground must be the correct size. Wires and cables must be free of corrosion. Wires and cables must have cable support clamps in order to prevent stress on battery connections (terminals).            
    Battery Test     12.4 VDC or more         Refer to Special Instruction, SEHS7633, "Battery Test Procedure".    
    Charging System Test     18 VDC to 32 VDC         Refer to Special Instruction, REHS0354, "Charging System Troubleshooting"    
    Electric Starting System Test     12 to 16 V at −23° C (−10° F) to
−7° C (19° F)            
14 to 18 V at
−7° C (19° F) to
10° C (50° F)
16 to 24 V at
10° C (50° F) to
27° C (80° F)
( 1 ) N = Normal, M = Monitor, A = ActionEngine
Cooling System
Table 2
Status (1)    Description    Specification    Actual    Comments    
    Radiator Pressure Relief (Radiator Cap) (2)     -            
    Freezing Point of Engine Coolant     -            
    Conditioner Test of Engine Coolant     -            
    Belt Tension     -         Refer to Operation and Maintenance Manual.    
    Difference between the Upper and Lower Radiator Tank Temperatures     -            
    Jacket Water Inlet Temperature from Cooling System    
86° 6.°C (186° 11°F)            
( 1 ) N = Normal, M = Monitor, A = Action
( 2 ) Test for the pressure that is listed on the cap.Fuel System
Table 3
Status (1)    Description    Specification    Actual    Comments    
    Fuel Pressure    
324 to 648 kPa (47 to 94 psi)            
( 1 ) N = Normal, M = Monitor, A = ActionLubrication System
Table 4
Status (1)    Description    Specification    Actual    Comments    
    Engine Oil Pressure at Low Idle    
207 to 600 kPa (30 to 87 psi)            
    Engine Oil Pressure at High Idle    
338 to 600 kPa (49 to 87 psi)            
( 1 ) N = Normal, M = Monitor, A = ActionBasic Engine