FILTER & LINES GP-POWER TRAIN 4366299 - Caterpillar

Power Harness and Fuse Installation
The 167-8703 Wire (Power Harness) is provided with the 291-2177 Machine Wiring Gp. Use the 167-8703 Wire to connect the 167-8984 Battery to the power supply of the machine.
Illustration 25 g01479356
Electrical schematic for Power Harness and installation of the fuses
Turn the disconnect switch to the OFF position.
Route the 167-8703 Wire from the 167-8984 Battery to the "Run" relay.Note: Use a 2L-8067 Terminal, a 2L-8071 Terminalor a 2L-8079 Terminal. These Terminals are included in the 291-2177 Machine Wiring Gp.
Connect the RED "+24 volt" wire to the supply side of the "Run" relay.
Connect the PINK "Switched +24 volt" wire to the switched side of the "Run" relay.
Connect the BLACK "Ground" wire to a ground lug.
Confirm that there is a 10 amp fuse in each of the 265-8147 Fuse Holders.Note: If the Run relay is not easily accessible, then the key switch may be used as a substitute connection point.Initial Power Checks
Before applying power to the CAESultra System for the first time, verify the voltage at the following power connections.Pin A - PositivePin B - NegativePin C - Switched positive
Turn off the Key switch.
Check for 24 V between Pin A and Pin B.
Check for zero V between Pin B and Pin C.
Turn the key switch to the ON positionNote: Do not turn the key all the way to the START position
Check for 24 V between Pin B and Pin C.
After power has been verified, connect the 3-pin connector of the 167-8703 Wire to the 3-pin connector of the 265-8147 Fuse Harness that is located near the 167-8984 BatteryMachine ID Worksheet Entries
Enter the following information for future reference:Machine ID Number____________________Machine Name____________________Display Serial Number____________________Machine Dimensions____________________Radio Serial Number____________________Application (Grade, Ore, OrePlus, Compaction)____________________Grade Tolerance (provided by Mine)____________________Dimension Measurements and Measure Up
Illustration 26 g01514107
Enter correct details. Any errors transfer directly into the finished surface.
Measure the machine GNSS receiver offsets. Reference the offsets to the specific dimensions of the machine for setting up the machine in the office from METSmanager.Refer to the sample METSmanager screen shot, Illustration 26, as a reference guide and template to record the machine dimensions.Note: The "X" measurement that is taken to the left of the centerline of the machine will be a negative number. The "X" measurement that is taken to the right of the centerline of the machine will be a positive number.Note: The "Y" measurement that is taken in front of the rear idler will be a positive number. The "Y" measurement that is taken behind the rear idler will be a negative number.
GPS x: Measure the distance from the center of the GNSS receiver (10) to the centerline of the machine.
GPS y: Measure the distance from the center of the GNSS receiver (10) to the center of the rear idler.
Illustration 27 g01514069
(10) 291-1913 Satellite Receiver As
(48) Top of lower housing
GPS z: Measure the distance from the top of the lower housing (48) of the GNSS receiver (10) to the bottom of the track.Note: When the machine is on soft terrain, measure to the bottom of