FILTER GP-PRIMARY FUEL 4W5421 - Caterpillar

Table 1
797 ATTACHMENT CODES (A And B Models)    
Attachment Code     Fuel Tank #
(1) (2) (3)     RAC Enabled
(Road Analysis Control)     TKPH Enabled
(Ton Kilometer Per Hour)    
1     1     No     No    
2     2     No     No    
3     3     No     No    
41     1     Yes     No    
42     2     Yes     No    
43     3     Yes     No    
51     1     No     Yes    
52     2     No     Yes    
53     3     No     Yes    
61     1     Yes     Yes    
62     2     Yes     Yes    
63     3     Yes     Yes    
( 1 ) 1000 Gal
( 2 ) 1600 Gal
( 3 ) 1800 Gal/1350 Gal
Table 2
785C, 789C, 793C, and 793D ATTACHMENT CODES    
Attachment Code     RAC Enabled     TKPH Enabled    
0     No     No    
4     Yes     No    
5     No     Yes    
6     Yes     Yes    
Table 3
785D and 789D ATTACHMENT CODES    
Attachment Code     Rated Engine Hp     RAC Enabled     TKPH Enabled    
1     2100/2200 Hp     No     No    
2     1900 Hp     No     No    
41     2100/2200 Hp     Yes     No    
42     1900 Hp     Yes     No    
51     2100/2200 Hp     No     Yes    
52     1900 Hp     No     Yes    
61     2100/2200 Hp     Yes     Yes    
62     1900 Hp     Yes     Yes    Note: Do NOT enter an attach code for the 2100/2200 Hp on a 1900 Hp 785D or 789D Truck. This mistake will cause a constant aftercooler level event to trigger. and you will not be able to change the attach code without flashing an older version of VIMS on the ECM.The following information describes the service program code: 288224 (ATTACH) This service program allows the operator to configure the attachment code. The Attachment Code is the software version of the Harness Code. The harness code is a hard wired configuration of jumper wires that ground certain circuits in a harness code plug. The VIMS broadcasts the attachment code via the Cat Data Link to other electronic control modules on the machine that need this code. Note: Applicable attachment codes are listed on the back of machine Electrical Schematic and in the Operations and Maintenance Manual.Note: VIMSpc must be running and connected to the machine to change the 288224 (ATTACH) code.Enter 288224 ATTACH on the VIMS keypad and press the "OK" key. The message center will show:
Illustration 1 g00485847
Enter the proper attachment code and press "OK". If a valid attachment code has been entered, the message center will prompt the operator to verify by re-entering the attachment code. The message center will show:
Illustration 2 g00485848
If the same code is entered again,