FILTER 5383560 - Caterpillar

Illustration 15 g02452910
Connect 304-7877 Cable As (20) to the 251-8248 Communication Cable As (17) on the ROPS.
Run the 304-7877 Cable As (20) under the rear access platform and connect to the switch assembly at the bottom port. Use 4P-7428 Clip (21) and cable straps as per the requirement.
Illustration 16 g02452912
Location of cable strap for holding the harness assemblies
Connect the 226-2862 Power Harness As (XA-C2) to the 226-2860 Monitor Harness As (XC-C1) (18) on the right-hand wall. Secure both the harness assemblies using the cable strap at the location shown in the Illustration 16. The illustration 16 shows the view looking toward the front from inside the manhole.
Illustration 17 g02456216
Illustration 18 g02456237
Illustration 19 g02452917
Remove the cover for the backup alarm (22) on the left rear of the machine. If there is only one pass-through hole, then drill a clearance hole for the 226-2865 Alarm Harness As (23) .
Illustration 20 g02456256
Illustration 21 g02452923
Route the 226-2865 Alarm Harness As (23) around the ROPS mounting assembly as shown in the Illustration 21. Secure the harness assembly using cable straps as per the requirement.
Illustration 22 g02452931
Route the 226-2865 Alarm Harness As (23) along the left fender wall and secure the harness with cable strap as per the requirement. Refer to Illustration 22 that shows the view of the manhole from the left fender wall.
Illustration 23 g02452933
Location of the cable strap to secure the harness assembly.
Complete the routing of the 226-2865 Alarm Harness As (23) by tie strapping at the location shown in the illustration 23 and finally connecting to the 226-2860 Monitor Harness As .Cable and Harness Reference
Table 2
PART NUMBER     DESCRIPTION     CONNECTIONS    
251-8248     Communication Cable As     From video camera pigtail harness to display pigtail harness    
304-7877     Cable As     From display harness to switch    
320-9715     Cable As     From ripper camera to switch    
226-2860     Monitor Harness As     From pigtail display harness to video power harness RF (XC-C1) and video power LF (XE-C1)    
226-2862     Power Harness As     From video power harness (XA-C2) to custom 24V switched power connector (RF-C14)    
226-2865     Alarm Harness As     From video power harness (XA-C3) to backup alarm