FILTER GROUP 8N8883 - Caterpillar

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin. At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the cooling system pressure cap is cool enough to touch with your bare hand.Remove the cooling system pressure cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Accumulated grease and oil on a machine is a fire hazard. Remove this debris with steam cleaning or high pressure water, at least every 1000 hours or each time any significant quantity of oil is spilled on a machine.
For maximum service life of the machine, perform a thorough daily inspection before you mount the machine and before you start the engine.Daily Basis
Daily, perform the procedures that are applicable to your machine:
Operation and Maintenance Manual, "Cooling System Coolant Level - Check"
Operation and Maintenance Manual, "Engine Oil Level - Check"
Operation and Maintenance Manual, "Fuel System Water Separator - Drain"
Operation and Maintenance Manual, "Fuel Tank Water and Sediment - Drain"
Operation and Maintenance Manual, "Hydraulic System Oil Level - Check"
Operation and Maintenance Manual, "Indicators and Gauges - Test"
Operation and Maintenance Manual, "Seat Belt - Inspect"
Operation and Maintenance Manual, "Travel Alarm - Test"
Operation and Maintenance Manual, "Undercarriage - Check"Refer to the Maintenance Section for the detailed procedures. Refer to the Maintenance Interval Schedule for a complete list of scheduled maintenance.Note: Watch closely for leaks. If you observe a leak, find the source of the leak and correct the leak. If you suspect a leak or you observe a leak, check the fluid levels more frequently.
Illustration 1 g01352569Inspect the lights for broken bulbs and for broken lenses. Replace any broken bulbs and any broken lenses.Inspect the engine compartment for any trash buildup. Remove any trash buildup from the engine compartment.Inspect the cooling system for any leaks, for faulty hoses and for any trash buildup. Correct any leaks. Remove any trash from the radiator.Inspect all of the belts for the engine attachments. Replace any belts that are worn, frayed, or broken.Inspect the hydraulic system for leaks. Inspect the tank, cylinder rod seals, hoses, tubes, plugs, connections, and fittings. Correct any leaks in the hydraulic system.Inspect the differential and the final drives for leaks. Make any necessary repairs.Inspect the swing drive for leaks.Make sure that all covers and guards are securely attached. Inspect the covers and the guards for damage.
Illustration 2 g01352575Inspect the steps, the walkways, and the handholds. Clean the steps, the walkways, and the handholds. Make any necessary repairs.Inspect the operator compartment for trash buildup. Check for trash buildup under the floorplate and on the crankcase guard. Keep these areas clean.Adjust the mirrors in order to achieve the best visibility.