FILTER GP-HYDRAULIC 9T8157 - Caterpillar

START BY:a. remove flywheelb. remove crankshaft rear seal and wear sleeve *c. remove electric starting motor*Remove the crankshaft rear seal and wear sleeve only if the engine is equipped with the later design seal. The later design seal can be identified by the rotation marks on the seal.1. Remove the bolts that hold the oil pan plate to the flywheel housing. Loosen the bolts that hold the oil pan plate to the cylinder block.2. Install spacers between the oil pan plate and the cylinder block to hold the oil pan plate away from the flywheel housing.
3304 Engine Shown3. Remove turbocharger oil drain pipe (2) and elbow (1) from the engine.4. Remove all bolts (3) and flywheel housing (4) from the engine.Install Flywheel Housing
1. Put the gasket and flywheel housing (1) in position on the engine as shown. Install the bolts while they are finger tight. 2. Tighten the bolts in the sequence shown to a torque of 100 14 N m (75 10 lb.ft.). 3. Install elbow (2) and turbocharger oil drain line (3).4. Cut the bottom of the flywheel housing gasket off even with the cylinder block and flywheel housing. Put 3S6252 RTV Silicone Adhesive/Sealant on the bottom of the gasket where it makes contact with the oil pan plate gasket.5. Remove the spacers from between the oil pan plate and the cylinder block. Install the bolts that hold the oil pan plate to the flywheel housing. Tighten the bolts that hold the oil pan plate to the cylinder block.END BY:a. install crankshaft rear seal and wear sleeveb. install flywheelc. install electric starting motor