FINAL DRIVE GP 1074898 - Caterpillar

Illustration 1 g01226922
Blade tilt right solenoid connections
Illustration 2 g01226938
Electronic hydraulic pilot manifold (1) Blade tilt right solenoid (2) Blade raise solenoid (3) Blade tilt left solenoid (4) Blade lower solenoidThis diagnostic code is associated with the blade tilt right solenoid. The FMI 05 means the ECM has determined that an open exists in the circuit for the solenoid.The possible causes of this diagnostic code are listed below:
The energize circuit of the solenoid is open
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. This is unlikely.Note: The following procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected.Ensure that the diagnostic code of CID 0497 FMI 05 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter of the measurements in this procedure.System Response:When this code is active, the implement lockout solenoid is deactivated (LOCKED) unless the limp home mode is selected. All implement functions are disabled. Test Step 1. CHECK THE SOLENOID
Turn the disconnect switch and the key start switch to the ON position. DO NOT start the engine.
Disconnect the blade tilt right solenoid from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire M928-BU) to contact 2 (wire H802-GY).
Observe the status of the CID 0497 FMI 05.Expected Result:The CID 0497 FMI 05 remains active. The FMI has not changed and the "05" is still active. Results:
YES - The diagnostic code remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2
NO - The diagnostic code is not active.Repair: The solenoid has failed. Repeat this Test Step "CHECK THE SOLENOID" in order to verify that the solenoid has failed. Replace the solenoid. Verify that the new solenoid corrects the problem. STOPTest Step 2. CHECK THE HARNESS FOR AN OPEN
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector J1 from the ECM.
The jumper wire that was installed in the previous test step remains in place.
At the machine harness connector, measure the resistance from signal contact J1-61 (wire M928-BU) to J1-60 (wire H802-GY). Expected Result:The resistance should be less than 5.0 ohms.Results:
OK - The resistance is less than 5.0 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5.0 ohms. The resistance measurement is not correct. There is an open or a bad connection in the machine harness. A resistance measurement that is much greater than 5 ohms but less than 5000 ohms could indicate that one of the connection points in the circuit is not open but is not a good connection.Repair: There is an open circuit or a bad connection in the machine harness. The problem is in the solenoid signal wire M928-BU or in the return H802-GY of the machine harness. Refer to the complete machine Electrical System Schematic and check all harness connectors that are in this