FINAL DRIVE GP 1C9875 - Caterpillar

Removal Procedure
Failure to properly service the batteries may cause peronal injury.Prevent sparks near the batteries. They could cause vapors to explode. Do not allow the jump start cable ends to contact each other or the machine.Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear eye protection when starting a machine with jump start cables.Improper jump start procedures can cause an explosion resulting in personal injury.Always connect the battery positive (+) to battery positive (+) and the battery negative (−) to battery negative (−).Jump start only with an energy source with the same voltage as the stalled machine.Turn off all lights and accessories on the stalled machine. Otherwise, they will operate when the energy source is connected.
Turn the battery disconnect switch to the OFF position.
Illustration 1 g03612816
Remove the bolts and covers (1).
Illustration 2 g03612903Note: The negative cable must be disconnected first.
Disconnect cable assemblies (3).
Disconnect cable assemblies (2).
Disconnect cable assemblies (4).
Illustration 3 g03613139
Disconnect clamps (5) and move cable assembly (2) out of the way, if necessary. Repeat this step for cable assembly (3) (not shown), if necessary.
Illustration 4 g03613257
Loosen nuts (6) enough in order to be able to remove hold-down brackets (7). Use two people in order to remove battery (8). The weight of battery (8) is approximately 27 kg (60 lb). Repeat this step for the remaining battery.
Repeat Step 7 for the remaining batteries. Installation Procedure
Install batteries (8) in the reverse order of removal. Note: The negative cable must be connected last.
Tighten nuts (6) to a torque of 6.8 1.4 N m (60.19 12.39 lb in).
Tighten the bolts for cable assemblies (4), (3), and (2) to a torque of 7.2 1.6 N m (63.73 14.16 lb in).