FIREWALL GP 1151128 - Caterpillar

Specifications
Illustration 1 g03737770
Illustration 2 g03818623
Table 1
Test Specifications
Date Product or Component SN
Component Location Specification Actual
The correct distance between the centerlines of pins (7) of tie rod (6). 1500 2 mm (59.05 0.01 inch) Introduction
Incorrect alignment of the front wheels may cause component wear and premature component failure. This procedure provides a method to determine if the alignment of the front wheels is correct. If the alignment is incorrect, this procedure also contains a method to adjust the front wheel alignment.Required Tools
Table 2
Required Tools
Tool Item Qty Part No Description
A 1 - Tape Measure Test Preparation
Park the machine on a smooth, horizontal surface.
Illustration 3 g03732361
Move propel lever (1) to the NEUTRAL position.
Move parking brake switch (2) to the ON position.
Illustration 4 g03741605
Illustration 5 g03741607
Press throttle control switch (3) in order to place the engine in low idle. Note: Two things indicate when the engine is at low idle. First, the engine rpm will appear on machine display (4). Second, the indicator light next to the throttle switch will go out.
Illustration 6 g03737031
Move engine start switch (5) to the OFF position in order to shut off the engine. Test Procedure
Illustration 7 g03737770
Illustration 8 g03818623
Use Tool (A) to measure the distance between the centerlines of pins (7) of tie rod (6). The distance should be 1500 2 mm (59.05 0.01 inch).
If the measurement is outside the specified range, go to "Adjustment Procedure". Adjustment Procedure
Illustration 9 g03737958
Illustration 10 g03737963
Loosen clamp bolt (8) on either side of tie rod (6). Adjust the tie rod until the distance between the centerlines of pins (7) of the tie rod is 1500 2 mm (59.05 0.01 inch).
Tighten clamp bolt (8) on both sides of the machine.