FITTING 2295465 - Caterpillar

Illustration 1 g00280782
Components for the Caterpillar Electronic Technician (ET) (1) IBM-compatible personal computer (2) 139-4166 Data Link Cable or 7X-1570 Data Link Cable (3) 7X-1425 Cable and 4C-6805 Adapter (4) Special Publication, NEXG4523, "Caterpillar Electronic Technician software" (5) 7X-1700 Communication Adapter Gp (5) 171-4400 Communication Adapter Gp The Caterpillar Electronic Technician (ET) is a software program that can be used on an IBM-compatible personal computer.Reference: To use the Caterpillar ET, order Special Publication, JERD2124, "ET Single Use Program License", Special Publication, JEHP1026, "Information and Requirements Sheet", and Special Publication, JERD2129, "Data Subscription". The Special Publication, JEHP1026, "Information and Requirements Sheet" lists the required hardware and the features of CAT ET.Caterpillar Electronic Technician (ET) is not needed for determining service codes or for clearing service codes, but using the ET is a faster, easier method. The ET can display information about the service code history and the ET can also display information about the parameter status. Because of these features, the ET is a useful service tool for troubleshooting.Caterpillar Electronic Technician (ET), which connects to the machine service connector, communicates with the electronic control modules (ECM) via the Caterpillar Data Link. The service connector is located behind the fuse panel access cover in the right interior panel of the cab.Reference: For more information, refer to the Service Manual module Testing and Adjusting, "Connector Locations".Reference: For more information on the electrical system and the components of the 824G Series II Wheel Tractor, 825G Series II Soil Compactor and 826G Series II Landfill Compactor, refer to the Service Manual module Schematic, "824G Series II Wheel Tractor, 825G Series II Soil Compactor & 826G Series II Landfill Compactor Electrical System".Connect Caterpillar Electronic Technician (ET) to the machine and start the ET. The ET will initiate communication with the electronic control modules (ECM) on the machine. After communication has been established, the ET will list the modules that are on the machine. Choose the menu item: "Transmission: Transmission 824G Series II", "Transmission: Transmission 825G Series II" and "Transmission: Transmission 826G Series II". After the service codes have been determined with the ET, see the test procedure for the corresponding service code.