FITTING 2M1908 - Caterpillar

: Hazardous AC and DC Voltages: This product contains hazardous AC and DC voltages. It is to be installed, operated, and serviced by trained and qualified personnel only, in accordance with national, and local regulations.
: Arc Flash Hazard And Electric Shock Hazard: To reduce the risk of arc flash and electrical shock injury to personnel, always comply with NFPA 70E, OSHA, and all other applicable electrical safety regulations when servicing any Caterpillar UPS equipment. Prior to performing service that requires opening a tool, access door, or removing a dead front panel, this equipment must be isolated from all sources of power.
CAUTION: Read this manual thoroughly. Pay special attention to the sections that apply to you before working with this system. Retain this section for use by the system installation personnel.The UPS system functions automatically and requires little attention during normal operation. However, make sure that you read and understand the procedures described in this manual to ensure trouble-free operation.This product contains hazardous AC and DC voltages. This product is to be installed, operated, and serviced by trained and qualified personnel only, in accordance with national, and local regulations.Underwriters Laboratories require that all 60HZ UPS systems must be installed with an appropriately rated service disconnect device for the output power (not supplied as standard product).If required by local and/or national regulations, appropriately rated service disconnect devices for input and output power must be provided.Over-current protection must be provided external to the UPS system in accordance with national and local electrical safety codes.To reduce the risk of fire: connect only to a circuit provided with 1600 Amps maximum branch circuit over-current protection in accordance with national and local codes and requirements.Low Voltage terminals marked "SELV / NEC-Class-2" should be connected to circuits of the same classification only. These circuits must be isolated from other circuits.In case of fire involving electrical equipment, only carbon dioxide fire extinguishers approved for use in electrical fire fighting must be used.Only test equipment designated for troubleshooting should be used. This warning specifically applies to oscilloscopes. Always check with an AC and DC voltmeter to ensure safety before making contact or using tools. Even when the power is turned Off, dangerously high voltages may exist at the capacitor banks.The flywheel units should be handled with care to avoid damage to moving and electrical components and injury resulting from mishandling. Under no circumstances should the flywheel system be moved while the flywheel rotor is turning or before the protective flywheel isolation bolts are in place.The controller board uses a lithium battery. When replacing the battery, replace with the same or equivalent type recommended by the manufacturer. Dispose of the used battery in accordance with the manufacturers instructions and local and national laws as applicable. There is a danger of an explosion if the battery is incorrectly replaced.Note: This manual contains important safety instructions that should be followed during system operation and installation. Read this manual thoroughly before working with this system. Under typical operation and with all