AVSPARE.COM
parts catalog

FITTING 3727416 - Caterpillar



3727416 FITTING Caterpillar parts 300.9D, 301.4C, 301.7D, 301.7D CR, 302.2D, 302.4D, 302.7D FITTING
Rating:
82
Alternative (cross code) number:
CA3727416
372-7416
3727416
Caterpillar 3727416 FITTING
Weight: 0.02 pounds 0 kg.

Buy FITTING 3727416 Caterpillar genuine, new aftermarket tractor parts with delivery
MINI HYD EXCAVATOR,

Compatible equipment models: 3727416:

MINI HYD EXCAVATOR  300.9D   301.4C   301.7D   301.7D CR   302.2D   302.4D   302.7D   Caterpillar
Number on catalog scheme: 2
 
  For full view, you need register

Information:

probable root causes are listed below:
Electrical power supply
Low fuel level
Fuel supply
Starting aids (if applicable)
Cranking speed
Shutdown switch
Active engine shutdown
Electrical connectors
Circuit breakers
Personality module
Engine speed/timing sensor
Injector solenoid
Air shutoff (if applicable)Perform the following checks:
Measure the voltage at the connector of the Electronic Control Module (ECM). If the ECM is not receiving battery voltage, the ECM will not power up. Refer to the diagnostic functional test Troubleshooting, "Electrical Power Supply".
Visually check the fuel level. If necessary, add fuel. Ensure the proper operation of the jacket water heater. Repair the jacket water heater and/or replace the jacket water heater. Check for the presence of solidified fuel (wax).
Check the fuel system. Check fuel lines for the following problems: restrictions, collapse, pinched line and loose fittings. Repair the lines and/or replace the lines.
Check the fuel tank for foreign objects which may block the fuel supply. Check for air in the low pressure fuel supply system after you perform the following procedures:
Replacing the fuel filters
Working on the low pressure fuel supply circuit
Replacing fuel injectors
Purge air from the low pressure fuel supply circuit with the hand priming pump and by cranking the engine in 30 second cycles. After you crank the engine, stop for two minutes. This will allow the starting motor to cool. Loosen the vent plug for the fuel return line. The plug is located on the rear upper left side of the engine block. Hand prime the engine again if air in fuel continues. A sight glass in the low pressure supply line is helpful in diagnosing air in the fuel.
Check fuel quality. In temperatures below 0 °C (32 °F), check for solidified fuel (wax). Refer to Special Publication, SEBD0717, "Diesel Fuels And Your Engine". Check the fuel pressure while the engine is cranking. Check the fuel pressure at the filter. If the pressure is low, check for plugged fuel filters. If the fuel pressure is still low, check the following items: fuel transfer pump, fuel transfer pump coupling and fuel pressure regulating valve.
If equipped, check the operation of the ether starting aids. Replace the ether canister if the ether is low. Refer to the diagnostic functional test Troubleshooting, "Ether Injection System".
Check the cranking speed of the starter.
The shutdown switch should be in the OFF position. Connect the Caterpillar Electronic Technician (ET). Use Cat ET in order to verify the status of the shutdown switch. If the Cat ET will not communicate with the ECM, refer to the diagnostic procedure Troubleshooting, "Electronic Service Tool Will Not Communicate with ECM". When a shutdown occurs, the keyswitch must be turned to the OFF position. The keyswitch must then be turned to the ON position before the engine will start.
Use Cat ET to determine if any active shutdowns are present. If a Shutdown is "ACTIVE", determine the reason. After you correct the problem, turn the keyswitch to the OFF position for at least 15 seconds before you try to restart the engine.
Check for correct installation of the following components: ECM connectors J1/P1 and J2/P2, customer connector, connector for

Caterpillar parts catalog:

Caterpillar parts catalog
300.9D Mini Hydraulic Excavator DW200001-UP (MACHINE)
300.9D Mini Hydraulic Excavator LJM00001-UP (MACHINE)
301.4C Mini Hydraulic Excavator LJK00001-UP (MACHINE)
302.7D CR Mini Hydraulic Excavator LJL00001-UP (MACHINE)
301.7D Mini Hydraulic Excavator LJH00001-UP (MACHINE)
302.4D Mini Hydraulic Excavator LJN00001-UP (MACHINE)
302.2D Mini Hydraulic Excavator LJG00001-UP (MACHINE)
301.7D CR Mini Hydraulic Excavator LJ800001-UP (MACHINE)
300.9D Mini Hydraulic Excavator LJ200001-UP (MACHINE)
301.4C Mini Hydraulic Excavator LJ300001-UP (MACHINE)
301.7D Mini Hydraulic Excavator LJ400001-UP (MACHINE)
302.2D Mini Hydraulic Excavator LJ500001-UP (MACHINE)
302.4D Mini Hydraulic Excavator LJ600001-UP (MACHINE)
302.7D CR Mini Hydraulic Excavator LJ700001-UP (MACHINE)


Parts fitting Caterpillar catalog:

0915928 FITTING-GREASE
301.4C, 301.5, 301.6C, 301.7D, 301.7D CR, 302.2D, 302.4D, 302.5, 302.5C, 302.7D, 303, 303.5, 303.5C, 303.5D, 303C CR, 304, 304.5, 304C CR, 304D CR, 305, 305C CR, 307D, 308D, 311C, 311D LRR, 312C, 312C...
1532996 FITTING AS
216, 228, 236, 248, 301.4C, 301.5, 301.6C, 301.7D, 301.7D CR, 303, 303.5, 303.5C, 303.5D, 303.5E, 303C CR, 304, 304.5, 304C CR, 304D CR, 304E, 305, 305.5D, 305.5E, 305C CR, 305D CR, 305E, 307D, 308D, ...
9H3771 FITTING-GREASE
301.4C, 301.7D, 301.7D CR, 302.2D, 302.4D, 302.7D, 303.5, 303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304C CR, 304D CR, 304E, 305.5D, 305.5E, 305C CR, 305D CR, 305E, 307D, 307E, 308D, 308E, 308E2 CR, 32...
1532997 FITTING AS
256C, 262C, 272C, 277C, 287C, 297C, 301.4C, 301.5, 301.6C, 301.7D, 301.7D CR, 303, 303.5, 303.5C, 303.5D, 303.5E, 303C CR, 304, 304.5, 304C CR, 304D CR, 304E, 305, 305.5D, 305.5E, 305C CR, 305D CR, 30...
3727413 FITTING
300.9D, 301.4C, 301.7D, 301.7D CR, 302.2D, 302.4D, 302.7D
3727420 FITTING
300.9D, 301.4C, 301.7D CR
3735672 FITTING
300.9D, 301.4C, 302.4D, 302.7D
3792538 FITTING
301.4C, 301.7D, 302.2D, 302.4D, 302.7D
4385043 FITTING AS
301.7D CR, 302.7D
3727413 FITTING
300.9D, 301.4C, 301.7D, 301.7D CR, 302.2D, 302.4D, 302.7D
3568087 FITTING-GREASE
308E CR, 308E SR, 311F LRR, 312E, 314E CR, 316E L, 320E, 320E RR
1572014 FITTING-HYDRAULIC
140M 2, 14M, 160M 2, 315D L
1232169 FITTING-ORFS
314D CR, 314D LCR, 321D LCR, 323D L, 323D LN, 323D SA, 324D, 324D LN, 325D, 325D L, 329D L, 329D LN, 330D L, 330D LN, 336D L, 844K, 966M, 966M XE, 972M, 972M XE, 980K, 980K HLG, 986H, 990K
2681621 FITTING AS
311F LRR, 314D CR, 314D LCR, 314E CR, 314E LCR, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 L, 320E LRR, 320E RR, 321D LCR, 323D L, 323D LN, 323D SA, 323D2 L, ...
2967059 FITTING AS
312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 314D CR, 314D LCR, 314E CR, 314E LCR, 320E L, 320E LN, 320E LRR, 321D LCR, 323E L, 324E L, 324E LN, 329E, 329E L, 329E LN, 336E, 336E L,...
3830386 FITTING
303.5E, 304E, 305.5E, 305E, 901C, 902C, 903C
3792538 FITTING
301.4C, 301.7D, 302.2D, 302.4D, 302.7D
3735672 FITTING
300.9D, 301.4C, 302.4D, 302.7D
3727420 FITTING
300.9D, 301.4C, 301.7D CR
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.