FITTING 4264043 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     236-8245     Lifting Gp - Body     1    
B     230-6387     Tool Gp - Body Pin Removal     1    
C     -     Bostik Never-Seez Marine Grade     -    
Illustration 1 g01183695
Install Tooling (A) and a suitable lifting device to ejector body (7) in four places. The combined weight of the ejector body assembly is approximately 10140 kg (22360 lb).
Illustration 2 g01183696
Align the bores of the ejector body and the rear frame. If necessary, install shims (10) (not shown) between the ejector body and the rear frame.
Apply Tooling (C) to pin assembly (9) prior to installation. Install pin assembly (9) .
Install plate (8) .
Repeat Step 2 through Step 4 to install the other side pin assembly.
Illustration 3 g01183694
Install the pin, washer (6) and bolt (5) .
Repeat Step 6 for the other side pin assembly.
Illustration 4 g01183693
View behind right side rear floodlamp
Connect electrical connector (4) .
Illustration 5 g01183692
View below the rear of the ejector body
Connect eight hose assemblies (3) .
Illustration 6 g01183691
Connect hose assembly (1) and two hose assemblies (2) .
Fill the hydraulic tank with oil to the correct level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".End By:
Remove the tailgate retaining pin. Refer to Disassembly and Assembly, "Tailgate Retaining Pin - Remove and Install".
Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".