FITTING 4B9003 - Caterpillar

ReferenceRefer to System Operation, Troubleshooting, and Testing and Adjusting, UENR2507, "Cat® Detect - Object Detection" for the proper orientation of the Object Detection sensors. The Object Detection sensors orientation is critical for the operation of the Object Detection system.Installation of the Radar Box Groups for the Object Detection (Rear)
Illustration 102 g03318703
View of the rear of the machine (46) 7X-7729 Washer (51) 8T-4195 Bolt (78) 349-4915 Bracket
Secure four 349-4915 Brackets (78) to the rear of the frame by using eight 8T-4195 Bolts (51) and eight 7X-7729 Washers (46) .
Illustration 103 g03318713
View of the rear of the machine (46) 7X-7729 Washer (57) 8T-4186 Bolt (58) 6V-7744 Locknut (78) 349-4915 Bracket
Secure two radar boxes (A) to two upper 349-4915 Brackets (78) and two radar boxes (B) to two lower 349-4915 Brackets (78) by using 16 8T-4186 Bolts (57), 32 7X-7729 Washers (46), and 16 6V-7744 Locknuts (58) .
Illustration 104 g03318237
Typical view of the rear of the machine (A) Upper radar box assembled with 372-9144 Bracket As (63) 380-6932 Bracket (64) 5C-9553 Bolt (65) 9X-8256 Washer
Secure four 380-6932 Brackets (63) onto the bracket assemblies for the radar boxes by using eight 5C-9553 Bolts (64) and eight 9X-8256 Washers (65) .Note: The 380-6932 Brackets (63) must be installed to help ensure that the radars are oriented in the proper location.Connect the Harness Assemblies (Rear)
Illustration 105 g03318716
View of the rear of the machine (60) 147-0385 Clip
Connect the four radars to the existing harness assembly.
Secure the wiring harness assembly to the bottom of the radar brackets by using the existing hardware and four 147-0385 Clips (60) .ReferenceRefer to System Operation, Troubleshooting, and Testing and Adjusting, UENR2507, "Cat® Detect - Object Detection" for the proper orientation of the Object Detection sensors. The Object Detection sensors orientation is critical for the operation of the Object Detection system.Flash the Software onto the Display
Software can be installed on the display using the following methods:J1939 Flash - Used to install software on a new display. The display will be blank when no software has been loaded.CAT Data Link Flash - Used to update current system.USB Flash - Used to save time when updating current systems or if a CDL error is encountered.Refer to Special Instruction, REHS7353, "Procedure for Installing Object Detection Software on Monitor Display Group of Certain Off-Highway Trucks" for additional details on software flashing.Software
Table 31
Part Number    System    Notes    
422-5263     Monitor Software Gp     Radar and Camera    
422-7022     Monitor Software Gp     Cameras only