FLANGE 1453204 - Caterpillar

Illustration 6 g01018048
Part of the 199-5284 Lift Cylinder Lines Gp (1) 210-4634 Tube As (2) 158-6667 Tube As (3) 195-6772 Tube As (4) 2M-9780 O-Ring Seal (5) 6V-8642 Connector (6) 6V-8626 Elbow (7) 7J-9108 O-Ring Seal
Install the 210-4634 Tube As (1) between Connection (O) of the lift cylinder hose assembly and Connection (M) of the cylinder-to-cylinder crossover line. Use a new 6V-8398 O-Ring Seal (14) at Connection (O). Use a new 7J-9108 O-Ring Seal (7) at Connection (M). See Illustration 6.
Install the 158-6667 Tube As (2) between Port (A) on the diverter valve and Connection (N) on tube assembly (1). Use the following parts for the connection at Port (A) : one 2M-9780 O-Ring Seal (4), one 6V-8642 Connector (5) and one 7J-9108 O-Ring Seal (7). Use a new 7J-9108 O-Ring Seal (7) at Connection (N) on tube assembly (1) .
Install the 195-6772 Tube As (3) between Port (B) on the diverter valve and Port (1A) on the bank valve. Use the following parts for the connection at Port (B) : one 2M-9780 O-Ring Seal (4), one 6V-8626 Elbow (6) and one 7J-9108 O-Ring Seal (7). Use a new 7J-9108 O-Ring Seal (7) for the connection at Port (1A) .Completing the Installation
Illustration 7 g00734645
Connect the 4-pin connector for the solenoid on the diverter valve (15) and the connector plug (C15) on the 142-8645 Platform Harness . See Illustration 7.Note: Connector plug (C15) is located inside the engine compartment on the right side wall.
Illustration 8 g00732872
The left hand control panel (12) 142-9116 Switch (13) 111-7899 Gasket
On the left hand control panel, remove the plug from the empty position on the control panel. Install the 142-9116 Switch (12) with the 111-7899 Gasket (13). See Illustration 8.
Illustration 9 g00732873
The fuse box
Install a 113-8491 Fuse (18) in the fuse block in the position that is indicated in Illustration 9.Appendix
Electrical Schematic
Illustration 10 g01018050
Connector A-C15 is part of the 142-8645 Platform Harness As . (S) 218-6857 Coil (Diverter Valve)