FLANGE AS 1T2073 - Caterpillar

Rework Procedure
TURBOCHARGER REPLACEMENT:
Refer to Disassembly and Assembly, RENR7460.
1. Replace the old turbocharger with the turbocharger that is listed in the Parts Needed.
2. Remove the line going from the Turbocharger to the waste-gate.
3. Using the 5M-6214 Pipe Plug, plug the orifice of the turbocharger as shown in Image1.1.1. Tighten the plug to 16 Nm.
Image1.1.1
3. Install the 1W-4795 Name Plate over the existing turbocharger name plate using a high temp epoxy or equivalent adhesive.
4. Using a scribe, etch the name plate with the part number 384-8812.
CENTER EXHAUST MANIFOLD - INSPECTION AND POSSIBLE REPLACEMENT:
An inspection of the center exhaust manifold must be completed prior to replacement. A picture of the failed manifold must be attached to the SIMS report.
Refer to the following images:
Failed manifold - Image1.3.1
Good manifold - Image1.3.2
If the center exhaust manifold is failed, install a new center exhaust manifold.
Image1.3.1
Image1.3.2
SOFTWARE INSTALLATION:
Upon completing the hardware update, a software update is required.
1. Using Cat ET, flash the ECM with the 381-7272 Software.
2. After completing the Software