FLANGE-WHEEL 3112535 - Caterpillar

"Engine Serial Number"
Program the "Engine Serial Number" to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM."ECM Serial Number"
This parameter identifies the serial number for the ECM."Software Group Part Number"
This parameter identifies the part number of the flash file that is currently installed in the ECM."Software Group Release Date"
This parameter identifies the release date of the flash file that is currently installed in the ECM."(FLS)" Full Load Setting
"FLS" is a parameter that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter."(FTS)" Full Torque Setting
"FTS" is similar to "FLS". Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter."Total Tattletale"
The total tattletale counts the number of changes to system parameters.Ether Solenoid Configuration
This parameter is enabled in order to define the installation status of an ether starting aid for the engine.Variable Pitch Engine Fan
The "variable pitch engine fan" aids in clearing debris from the radiator.Engine Fan Control
This parameter aids in controlling the engine fan.Prelube Enable
This feature allows the engine prelube to be enabled or disabled.Parameter Table
Table 1
System Configuration Parameters
Parameter Available Range or Options Default Required Password
Configuration Group 1
"Equipment ID" 17 alphanumeric characters Blank None
ECM Identification Parameters
"Engine Serial Number" 0XX00000 or XXX00000 Blank Factory
"ECM Serial Number" Hardware Dependent Blank Read Only(1)
"Software Group Part Number" Software Dependent Read Only(1)
"Software Group Release Date" Software Dependent Read Only(1)
System Parameters
"FLS" Programmed at the Factory Factory
"FTS" Programmed at the Factory Factory
"Total Tattletale" 0 to 65535 0 Read Only(1)
Engine Configuration Parameters
"Ether Solenoid Configuration" Not Installed
Continuous Flow Solenoid Continuous Flow Solenoid Customer
"Variable Pitch Engine Fan" Enabled
Disabled Disabled None
"Engine Fan Control" On
Off On Customer
"Prelube Enable" On
Off Off Customer
(1) This parameter can be viewed only. No changes are allowed.Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters
"Equipment ID"
"Engine Serial Number"
"ECM Serial Number"
"ECM Part Number"
"Software Group Part Number"
"Software Group Release Date"
"Total Tattletale"
"FLS"
"FTS"
"Ether Solenoid Configuration"
"Variable Pitch Engine Fan"
"Engine Fan Control"
"Prelube Enable"
Table 3
Information From Engine Information Plate
Engine Serial Number
"FLS"
"FTS"
Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Use of incorrect parameters could cause damage to the engine. Use of the incorrect parameters may also void the Caterpillar warranty or the emission certification for the engine.