FLANGE GP-EXH 5088607 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 308-3470 Repair Stand 2
B 308-3471 Repair Stand 2
C 1U-9745 Air/Hydraulic Jack Gp 1
D 1P-0520 Driver Gp 1
Illustration 1 g01515522
Use Tooling (D) in order to install bushing (9) and seal (8). Repeat this step for the other side. Note: Do not apply any lubricant to the inside diameter of seal (8) or bushing (9).
Illustration 2 g01515454
Attach a suitable lifting device to both sides of front drive and steering axle (4). The weight of front drive and steering axle (4) is approximately 408 kg (900 lb). Use the suitable lifting device in order to position front drive and steering axle (4) to the machine.
Illustration 3 g01515475
Illustration 4 g01516006
Position washers (6) and thrust washers (7) to both sides of front drive and steering axle (4) while you are installing pin assembly (5). Note: Use the required amount of washers (6) on the front side of front drive and steering axle (4) in order to maintain a gap of 0.8 mm (0.03 inch) maximum.Note: Do not apply any lubricant to pin assembly (5). Note: The flange of pin assembly (5) must be rotated downward before installation in order to clear the frame.
Illustration 5 g01515414
Install bolt (3).
Connect hose assembly (2). Repeat for the opposite side of the machine.
Illustration 6 g01515297
Install the counterweight. Refer to Disassembly and Assembly, "Counterweight - Remove and Install".
Install the front tires and rims. Refer to Disassembly and Assembly, "Tire and Rim (Front) - Remove and Install".
Use Tooling (C) in order to remove Tooling (B) under the front of the machine.
Illustration 7 g01515289
Use Tooling (C) in order to remove Tooling (A) from the rear of the machine.
Illustration 8 g01237930
Remove lift cylinder brace (1) and lower the bucket. End By:
Install the front drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Front) - Remove and Install".