FLANGE 9R5455 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g01167014
Turn valve (1) to the OFF position.
Illustration 2 g01167195
Remove filter (6) and drain the contents into a suitable container for storage or disposal.
Disconnect hose assembly (4) and tube assembly (5) .
Remove bolts (2) and base assembly (3) .Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 3 g01167195
Position base assembly (3) and install bolts (2) .
Connect hose assembly (4) and tube assembly (5) .
Install filter (6) .
Illustration 4 g01167014
Turn valve (1) to the ON position.
Purge the air from the fuel system.