FLAP-RUBBER 2550972 - Caterpillar

Illustration 7 g02349908
View of the rod end (G) of the articulation cylinder
Illustration 8 g02349915
View of washers (5)
The rod end of the articulation cylinder is shown at location (G) in Illustrations 7 and 8. Installation of washers (5) should start on the bottom of the rod end (H) of the articulation cylinder.
Install washer (5) at the first location (H) at the bottom of the rod end of the articulation cylinder.
Install washer (5) at the second location (F) on the top of the rod end of the articulation cylinder.
Illustration 9 g02349920
View of odd number shimming at the bottom of the clevis jointThis view shows two washers (5) on the top and three washers (5) on bottom.
If an odd number of washers in the joint is necessary, place the extra washer at the bottom area of the clevis joint.
Referring to Illustration 9, install washer (5) to location (H) first. Next, install washer (5) to location (F). Alternate from bottom (H) to top (F) until the joint cannot accept anymore washers (5) .
Illustration 10 g02349917
View of pin assembly (S) and hardware installed
Illustration 11 g02350077
View of bolt, bushing, and washer installed
Referring to Illustrations 10 and 11, after installation of the washers is completed, insert pin assembly (S). Reuse cotter pin (J), bushing (K), hard washer (L), and bolt (M)