FLOAT AR-BLADE 2713652 - Caterpillar

(24)Transmission, Bevel Gear And Torque Converter Compartments
Whenever draining lubricant extreme caution should be used. Lubricant may be hot and can cause personal injury.
Machine must be level, engine stopped, blade lowered with slight down pressure and brake lock applied. 1. Open access door to filter housing. Remove cover and used element. 2. Remove element retainer nut, retainer and element from cover. 3. Clean cover. Inspect seal and use new seal if necessary. 4. Install new element to cover. Tighten element retaining nut to 10 2 lb ft (14 3 N m). Install cover assembly. Close access door. 5. Open access door. Remove cover, spring, screen and magnets.
When using pressure air wear protective face shield and protective clothing. Maximum air pressure must be below 30 PSI (205 kPa).Use all cleaning solutions with care.
Do not drop or rap magnets against hard objects. Replace any damaged magnets.
6. Wash screen and magnets in clean nonflammable solvent. Clean magnets with a cloth, stiff brush or pressure air. 7. Inspect seal. Install new seal if necessary.8. Install screen and magnets.9. Install spring and cover.10. Start engine and run at low idle for a few minutes to circulate oil. Inspect for leaks. 11. Measure oil level. Maintain oil level between FULL and ADD marks on dipstick. Add oil if necessary.(25)Tilt Cylinder Control Linkage
Lubricate 1 fitting (if equipped).(26)Steering Clutch Brakes
Measure adjustment. Adjust brakes when pedal travel reached 6 to 61/4 inches (15 to 16 cm).Adjustment:
1. Remove guard and cover. Tighten nut. 2. Loosen locknut. Tighten screw until tight, then back screw out 1 1/2 turns. Tighten locknut. 3. Loosen nut 3 turns.4. Adjust opposite brake the same way. Check adjustment.5. Install cover and guard.(27)Hydraulic Control Linkage
Lubricate 1 fitting (if equipped).(28)Track
Tracks should be adjusted under the same conditions in which the machine will be used. If packing conditions prevail on the job, the tracks should be adjusted with packing present.Run the tractor forward at least twice the length of the tractor, then allow tractor to coast to a stop. Do not brake tractor to stop it.Hydraulic Adjustment
Do not attempt to tighten track when measurement at "A" is less than .25 inch (6 mm). Contact your Caterpillar dealer for track service.
1. Raise inspection plate and add multipurpose-type grease through fill valve until idler moves forward and track is tight. 2. Make a mark on the roller frame 1/2 inch (1 cm) behind the idler bearing support. 3. Be sure there is space for front idler to retract. Raise inspection plate.
Never visually inspect relief valve or fill valve to see if grease is escaping. Always observe the track to see if it has loosened.Open relief valve one turn only.
4. Open relief valve and allow the idler to move back. Moving the machine back and forth will help move the idler back. 5. Close relief valve. 6. Add MPG through fill valve until mark on roller frame is aligned with rear edge of idler bearing support.Mechanical Adjustment
1. Remove guard. Loosen rod clamp nuts.
Do not tighten track when dimension (A)