FLOOR MAT 1924556 - Caterpillar

Machine Preparation
Clear all personnel from the machine and from the area around the machine.
Start the engine.
Illustration 2 g02449876
Engine speed dial
Set the engine speed dial at "10".
Lower the left console.
Position the machine on level ground. Check the visibility and adjust the mirrors for the best vision close to the machine.
Fully depress the service brake pedal until the service brake pedal locks mechanically.
Increase the hydraulic oil temperature to 46 to 80° C (115 to 176° F).
Lower the stabilizers and the blade tip.
Fully extend the bucket cylinder and place the bucket on the ground.
Stop the engine.
Release the pressure in the hydraulic system.Note: Refer to Testing and Adjusting, "System Pressure - Release".
Raise the left console.
Illustration 3 g02451756
Medium pressure tap is located behind the left rear access door.
Attach Tooling (B2) 34,450 kPa (5,000 psi) pressure sensor to the medium pressure tap.
Start the engine.
Set the engine speed dial at "10".
Illustration 4 g02552721
Power mode control button located on the soft panel switch
Push down on the power mode control button in order to activate power mode.Note: The indicator light will be illuminated when power mode is activated.
Lower the left console.
Use the Monitor in the cab in order to disable the Automatic Engine Speed Control.
Select the "Performance" menu from the main menu on the monitor.
Select "AESC Status" from the "Performance" menu and change the value to "Inactive".
Press the "OK" key.
Illustration 5 g02447064
Joystick (front switch)
Disable the hydraulic modulation control, if equipped. Press the front switch on the right joystick in order to deactivate hydraulic modulation.
The air conditioning should be turned off for the following test.Test and Adjust Procedure (LS Cutoff)
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Illustration 6 g02451757
Medium pressure manifold (1) Adjustment screw (2) Locknut (3) Relief valve (LS Cutoff) for the medium pressure functionNote: M300D machines can be equipped with one, two, or three medium pressure functions. The following medium pressure functions are from left to right: the hydraulic cab riser function or the offset boom function, the grapple rotate function and the joystick steering (priority function).
Operate the medium pressure attachment against the end position of the cylinders.
Check the pressure at the medium pressure tap.Note: Refer to Table 2 for the correct pressure.
If the line relief valve pressure is not set to the proper specification, adjust the pressure at the appropriate relief valve.
Loosen locknut (2) on relief valve (3) .
While the attachment is stalled, turn adjustment screw (1) , on relief valve (3) until the medium pressure tap is set to the correct pressure.Note: Turn the adjustment screw clockwise in order to increase the pressure. Turn the adjustment screw counterclockwise in order to decrease the pressure.Note: Pressure will increase 5000 kPa (725 psi) when the adjustment screw is moved clockwise by one turn.Note: Always make the final pressure adjustment on the pressure rise.
Tighten locknut (2) on relief valve (3) to the specified