FLOOR MAT 2618619 - Caterpillar

Shut down the engine.
Illustration 3 g00807845
This view is of the left side of the engine. This view shows the former accumulator. (1) 148-7610 Tube As (2) 148-7624 Bracket (3) Support Clip and Bracket (4) 130-1498 Accumulator
Disconnect the tube assembly (1) from the accumulator (4). Remove the bracket and clip (3) and remove the accumulator (4). Remove the support bracket (2) .
Illustration 4 g00807878
This view is of the left side of the engine. This view shows the new accumulator. (1) 148-7610 Tube As (5) 6V-8733 Face Seal Union (6) 198-7779 Bracket (7) 0S-1608 Bolts and 3V-3308 Hard Washers (8) 126-3005 Pipes (9) 170-0990 Clamps (10) 158-2940 Hose As (11) Protective Cover (12) Charging Valve (13) 201-9561 Turbocharger Oil Accumulator Gp (14) 0S-1590 Bolts and 3V-3308 Hard Washers (15) 9S-8752 Full Nuts and 3V-3308 Hard Washers (16) 6V-8637 Seal Connector
Install the bracket (6) with four bolts and hard washers (14). The new bracket should be installed to the left of the former bracket. The new bracket is installed on a lower crankcase cover.
Install the 3D-2824 O-Ring Seal and Seal Connector (16) in the accumulator (13) .
Loosely fasten the accumulator (13) to the bracket (6) with the following components:
Two clamps (10)
Four bolts and hard washers (7)
Four pipes (8)
Four full nuts and hard washers (15)
Install the 6V-9746 O-Ring Seal and the face seal union (5) in the tube assembly (1) .
Use two 6V-9746 O-Ring Seal in order to install the hose assembly (10) .
Illustration 5 g00808059
This view is of SECTION A-A. (17) The existing 148-7622 Bracket (18) 3B-1915 Bolt and 3V-3308 Hard Washer (19) 7G-4326 Plate (20) 0S-1594 Bolt (21) 3V-3308 Hard Washers (22) 9S-8752 Full Nut (23) 5K-9660 Clip
Remove the bolt that is in lower right side of the existing bracket (17) .
Loosely install the plate (19) with the bolt and hard washer (18) .
Install the clip (23) on the tube assembly (1) .
Loosely fasten the clip (23) to the plate (19) with the bolt (20), two hard washers (21), and the full nut (22) .
After the components are in alignment, tighten all of the mounting hardware. Tighten the ends of the hose assembly (10) and the end of the tube assembly (1) .
Remove the protective cover (11) from the accumulator.
Personal injury or death can result from improper accumulator charging.Dry nitrogen is the only gas approved for use in the accumulator. Charging the accumulator with oxygen gas will cause an explosion. This danger will not happen if nitrogen cylinders with standard CGA Compressed Gas Association, Inc.Number 580 connections are used.When ordering nitrogen gas, be sure that the cylinders are equipped with CGA Number 580 Connections. Do not use color codes or other methods of identification to tell the difference between nitrogen and oxygen cylinders.Never use an adapter to connect your nitrogen charging group to a valve outlet used on both nitrogen, oxygen or other gas cylinders. Be sure you use dry nitrogen (99.8 % purity).
Use the correct tools to connect the container of