FLOOR MAT 2841602 - Caterpillar

Illustration 1 g01211490
Illustration 2 g03623137
Illustration 3 g06343707
Two Bolt Style
Illustration 4 g06343719
Three Bolt Style
Use a suitable press to install shaft (9) into bracket assembly (17).Note: Ensure that the lubrication ports (Z) of shaft (9) are orientated as shown facing up.Note: Lubricate shaft (9) prior to installation.Note: To prevent damage to bracket assembly (17), support bracket assembly (17) at Surface (X) as shaft (9) is installed.Note: The measurement from the base of shaft (9) to the top of shaft (9) should be 118.5 0.75 mm (4.67 0.03 inch) after installation.
Install bolt (16) and the washer that holds shaft (9) to bracket assembly (17).
Illustration 5 g01211485
Install sleeve (15) to shaft (9), as shown.
Illustration 6 g01211987
Position fan pulley hub (3), as shown. Install bearing cup (14) to fan pulley hub (3). Use a hammer and brass drift to ensure that bearing cup (14) is seated.
Illustration 7 g01212121
Illustration 8 g01212125
Position fan pulley hub (3), as shown. Install bearing cup (13) to fan pulley hub (3). Use a hammer and brass drift to ensure that bearing cup (13) is seated.
Place the bearing cone (not shown) into bearing cup (13).
Lubricate lip seal (12) (not shown) with the lubricant that is being sealed. Use Tooling (A) to install lip seal (12) (not shown) to fan pulley hub (3).
Illustration 9 g03651101
Position fan pulley hub (3) to shaft (9), as shown. Install spacer (11) to shaft (9).
Illustration 10 g03654210
Install bearing cone (10) to fan pulley hub (3).
Illustration 11 g03653862
Position retaining plate (8), as shown. Install bolts (7).
Illustration 12 g03654248
Attach a suitable lifting device to fan drive pulley (5).
Position fan drive pulley (5) to fan pulley hub (3). Install bolts (6) that hold fan drive pulley (5) to fan pulley hub (3). The weight of fan drive pulley (5) is approximately 65 kg (144 lb).
Illustration 13 g01052047
Install O-ring seal (4) to adapter (1).
Illustration 14 g01211375
Position adapter (1) to fan pulley hub (3). Install bolts (2) that hold adapter (1) to fan pulley hub (3).End By:
Install the fan drive. Refer to Disassembly and Assembly, "Fan Drive - Install".