FLOOR MAT 8W6061 - Caterpillar

Illustration 31 g06019924
Install bolts (24) into the housing assembly. Tighten bolts (24) to a torque of 60 7 N m (45 5 lb ft).
Illustration 32 g06019922
Install ring (23) to shaft (19).
Illustration 33 g06020232
Raise the temperature of carrier (21) and bearing (20) to a temperature of 149 °C (300 °F).
Install the seal carrier and the bearing onto shaft (19).
Install rings (22) onto carrier (21).
Illustration 34 g06019882
Use Tooling (A) and a suitable lifting device to install shaft (19) into the torque converter.
Illustration 35 g06019879
Lubricate the bore of the O-ring seal lightly with the lubricant that being sealed.
Install O-ring seal (17) on stator carrier (18).
Illustration 36 g06019878
Lubricate the sealing lip lightly with the lubricant that being sealed.
Install lip seal (15) in retainer (16).
Illustration 37 g06019877
Install the gasket and retainer (15).
Install bolts (14). Tighten bolts (14) to a torque of 60 7 N m (45 5 lb ft).
Illustration 38 g06019876
Install O-ring seal (13) into yoke (11).Note: Apply Tooling (E) to the O-ring seal to hold the O-ring seal in place during assembly.
Illustration 39 g06019874
Install yoke (11) and retainer (12).
Install bolt (10) on shaft (19). Tighten bolt (10) to a torque of 240 25 N m (175 20 lb ft).
Illustration 40 g06019868
Install dowel pins (9) into housing assembly (3).
Use Tooling (B) and a suitable lifting device to install housing assembly (3) onto the torque converter assembly. The weight of housing assembly (3) is approximately 110 kg (243 lb).
Illustration 41 g06019869
Install bolts (8) in the housing assembly.
Illustration 42 g06019864
Lubricate the bore of the O-ring seal lightly with the lubricant that being sealed.
Install O-ring seal (5), sleeve (6), and O-ring seal (7) into housing assembly (3).
Illustration 43 g06019862
Install O-ring seals (4) in housing (1).Note: Apply Tooling (E) on the O-ring seals to hold the O-ring seals in place during the assembly.
Illustration 44 g06019861
Install housing (1) onto housing assembly (3).
Install bolts (2).End by:a. Install the torque converter.