FLYWHEEL AS 1W7605 - Caterpillar

Table 4
Contact Description J2(1)
No.(2) Function Type
1 Key Switch Start Start
2 Main Power Relay Driver On/Off Std
3 Parking Brake Dump Valve Solenoid 2A On/Off Std
4 Load Return (1) Load Return
5 Secondary Brake Dump Valve Solenoid 2A On/Off Std
6 Backup Alarm 2A On/Off Std
7 Neutral Start Relay 2A On/Off Std
8 Load Return 2 Load Return 2
12 FWD ROPS Relay Driver 0.3A Sink
14 Alternator R Term R Term
22 Digital Return GND
23 Steering Filter Bypass Switch Switch To Ground
24 Left Clutch/Brake Steering Input STG/PWM
25 Right Clutch/Brake Steering Input STG/PWM
28 Upshift Sw (NO) SWG
29 Upshift Sw (NC) SWG
30 Downshift Sw (NO) SWG
31 Downshift Sw (NC) SWG
32 Service Brake Pedal Position Sensor Pulse Width Modulation
34 Steering Motor Speed Sensor 1 STG/PWM
35 Steering Motor Speed Sensor 2 STG/PWM
36 Forward Switch (NO) Switch To Ground
37 Forward Switch (NC) Switch To Ground
38 Enhanced Autoshift (N. O.) Switch To Ground
39 Enhanced Autoshift (N. C.) Switch To Ground
42 Thumbwheel PWM Shift STG/PWM
44 Harness Code 0 Switch To Ground
45 Harness Code 1 Switch To Ground
46 Harness Code (2) Switch To Ground
47 Harness Code (3) Switch To Ground
48 FNR 1 Signal STG/PWM
49 FNR 2 Signal STG/PWM
58 Access Ladder STG/PWM
60 Power Train Oil Level Sensor Switch To Ground
61 Remote Control Enable Switch To Ground
64 Hour Meter Can High CAN B +
65 Hour Meter Can Low CAN B -
67 Can Data Link A+
(J1939) CAN A +
68 Can Data Link A-
(J1939) CAN A -
(1) The ECM responds to an active input only when all the necessary conditions are satisfied.
(2) The connector contacts that are not listed are not used.Display Module (Dash)
Illustration 3 g00901469
Rear view of monitor
(1) 24 pin connector
Table 5
Contact Description
Contact
Number Function Type
1 +Battery Power
2 -Battery Ground
3 Keyswitch Input Ground
8 Horn Output Driver Output
11 Can Data Link (+) Input/Output
12 Can Data Link (-) Input/Output Advisor
Illustration 4 g01118927
Rear view of the Advisor
Table 6
Contact Description for the Advisor Electronic Control Module
Contact
Number Function Type
1 Battery (12 or 24 DCV) + Battery
2 GND − Battery
3 Key Switch Ground
4 Parking Lamp (Dimming) Output
8 Cat Data Link + Input/Output
9 Cat Data Link - Input/Output
34 Can Data Link + Input/Output
50 Can Data Link - Input/Output
54 Rear Action Lamp Output
55 Rear Action Lamp Return Return
66 Chassis Ground Ground