FLYWHEEL AS 4829074 - Caterpillar

Table 1
Service Tools
Part Number Part
146-4080 Digital Multimeter
7X-1710 Multimeter Probe Group
8T-8726 "3 Pin Cable Assembly"
6V-3000 Connector Repair Kit (Sure Seal)
9U-7246 Connector Repair Kit (Deutsch DT Type)
4C-3406 Connector Repair Kit (Deutsch)
8T-3224 Needle Tip Group
4C-8195 Control Service Tool (Switch Box)
157-4829 Cable Adapter
317-7485(1) Caterpillar Communication Adapter 3 (2)
327-8981(1) Com Adapter 3, Data Link Cable Assembly (3)
370-4617(1) Com Adapter 3, PC USB Cable (4)
Caterpillar Electronic Technician (Cat ET)
Plus+1 Service Tool for Caterpillar software
300-7924(2) Communication Cable, CAN (DB9) to USB adapter
300-7925(2) Communication Cable As., DB9 PC Serial Port to 3-pin receptacle Deutsch connector adapter
309-5667(2) Adapter Cable As., 9-pin Deutsch connector plug (Service Port) to 3-pin Deutsch connector adapter
(1) Part of 317-7484 Adapter Gp
(2) Required for ECM “Recovery” ProcedureNote: The ECM “Recovery” cables can be used with any instructions contained in this manual. The requirement of an ECM recovery procedure while troubleshooting or servicing the machine is highly unlikely.
Illustration 1 g02615483
Components of the Communication Adapter 3 Gp (317-7484) are listed:
(1) Current version of Cat ET software for use with a Windows-based personal computer
(2) 317-7485 Control Gp-Electronic (Com Adapter 3)
(3) 327-8981 Cable As. (Data Link Cable CA3)
(4) 370-4617 Cable As. (CA3 PC USB Cable)Note: Plus+1 Service Tool for Caterpillar software will be required in addition to Cat ET software.Reference: See “Obtaining ECM Diagnostic And Flash Files” within Troubleshooting, "Determining Diagnostic Trouble Codes" for detailed instruction for the use of the diagnostic file.For instructions on servicing Sure Seal connectors, see Special Instruction, SMHS7531. For instructions on servicing Deutsch DT connectors, see Special Instruction, SEHS9516.Use the digital multimeter for making continuity checks or for measuring voltage. The 7X-1710 Multimeter Probe is used to measure the voltage without disconnecting the connector. The probe cables are pushed into the back of the connector along the wire. The 8T-8726 Adapter Cable has a breakout of 3 pins. The adapter cable is used for measurements in the sensor circuits.Note: Except for the harness tests, the following are not recommended for Caterpillar electrical circuits:
Continuity Testers (such as the 8T-0500 Continuity Tester)
Voltage Testers (such as the 5P-7277 Voltage Tester)