FLYWHEEL GP 6I0261 - Caterpillar

Assembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Compressor housing must go straight on the turbocharger assembly without tilting. Tilting may cause compressor blade to tip, or the compressor shaft can be damaged.
Illustration 1 g01237470
Position compressor housing (1) and turbine housing (4) on turbocharger cartridge (5). Note: Ensure that the mating surfaces are flush.
Tighten the nuts on V-band clamp (2) to a torque of 14 1 N m (10 1 lb ft). Use a soft hammer to lightly hit around the diameter of the band clamp. Tighten the nuts again to a torque of 14 1 N m (10 1 lb ft).
Tighten the nuts on V-band clamp (6) to a torque of 14 1 N m (10 1 lb ft). Use a soft hammer to lightly hit around the diameter of the band clamp. Tighten the nuts again to a torque of 14 1 N m (10 1 lb ft).
Ensure that the impeller spins freely.
Connect hose (3) to the compressor housing. End By:
Install the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".