FLYWHEEL AS 6N5162 - Caterpillar

Illustration 2 g01403100
Illustration 3 g02597536
Attach Tooling (A), Tooling (B), and a suitable lifting device to torque converter (18). Position the suitable lifting devices around firewall (17). The weight of torque converter (18) is approximately 1084 kg (2390 lb). Position torque converter (18) .
Illustration 4 g02597763
Illustration 5 g02597704
Attach an additional Tooling (A) to position torque converter (18) onto the rear pump drive.
Install bolts (20) .
Illustration 6 g02597663
Install bolts (19) .
Illustration 7 g02477415
Use Tooling (C) and a suitable lifting device to install cover assembly (16). The weight of cover assembly is approximately 35 kg (77 lb).
Illustration 8 g02597437
Connect hose assemblies (15) .
Illustration 9 g02597296
Install yoke (14). Install the O-ring seal, washer (13) and bolt (12) .
Illustration 10 g02597158
Connect tee (11) .
Illustration 11 g02597261
Connect harness assembly (9) and install clip (10) .
Illustration 12 g02477406
Connect hose assemblies (7) .
Illustration 13 g02477410
Install valve (6) .
Illustration 14 g02477401
Connect hose assemblies (5) .
Illustration 15 g01403087
Install block (3). Install clips (4). Connect hose assemblies (2) .
Illustration 16 g01403086
Connect hose assembly (1) .
Fill the steering hydraulic tank and the brake hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil (Steering, Brake) - Change".End By:
Install the rear drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Rear) - Remove and Install".
Install the input drive shaft. Refer to Disassembly and Assembly, "Input Drive Shaft - Remove and Install".
Install the transmission oil pump. Refer to Disassembly and Assembly, "Transmission oil pump (Charge) - Install".
Install the power train guard. Refer to Disassembly and Assembly, "Power train Guard (Transmission) - Remove and Install".