FORESTRY AR- 2669000 - Caterpillar

Table 3
Required Parts    
Part Number     Description     Qty    
186-3736     Connector Socket     1    
N/A     Momentary Switch     1    
N/A     16 AWG Wire     (1)    
( 1 ) Fabricated to length
Determine the location for the switch. A momentary switch that is normally open should be used.
Fabricate a piece of 16 AWG wire to reach from the control module to the switch.
Crimp an 186-3736 Connector Socket to one end of the wire.
Insert the connector socket into pin 5 (Dimming Input). Connect the remaining end of the wire to the switch.
Fabricate a wire to reach from the switch to the negative battery.
Connect the switch to the negative battery bus bar.Connecting the Gauges to the Control Module
Illustration 5 g00888970
Schematic for the analog gauges
Connecting the gauges to the control module without an extension harness Refer to Illustration 5.Note: An extension harness should only be used when the control module can not be placed close to the gauges.
Connect a 212-8255 Harness As (Y) to the J45 Gauge connector on the 210-4309 Control Module .
Connect a 212-8259 Harness As (Termination) to the 212-8255 Harness As (Y) that is connected to the control module.
Connect a 174-3016 Plug (Termination Resistor) to the 212-8259 Harness As (Termination).
Connect another 212-8255 Harness As (Y) to the first 212-8255 Harness As (Y). Continue to connect the 212-8255 Harness As (Y) until the desired number of gauges are connected to the control module.Note: A maximum of 12 gauges can be connected to