FORK AS 1046312 - Caterpillar

Illustration 1 g01136679
Remove plug (1). Drain the oil into a suitable container for storage or for disposal.
Illustration 2 g01136680
Remove plug (2). Drain the oil into a suitable container for storage or for disposal. Remove bolts (3) .
Illustration 3 g01136685
Install Tooling (A) and Tooling (B) .
Illustration 4 g01136686
Slide final drive (4) outward. Attach Tooling (C) and a suitable lifting device onto final drive (4). The weight of final drive (4) is approximately 52 kg (115 lb). Remove Tooling (A) and Tooling (B) .
Illustration 5 g01136687
Remove final drive (4). Remove O-ring seal (5) .
Illustration 6 g01136688
Remove bolt (6), sun gear (7), and sleeve (8) .
Illustration 7 g01136690
Attach a suitable lifting device onto lever (9). Remove bolts (10) and position lever (9) out of the way.
Illustration 8 g01136692
Remove bolts (11). Remove cover (12) .
Illustration 9 g01136693
Attach Tooling (D) and a suitable lifting device onto hub assembly (13). The weight of hub assembly (13) is approximately 246 kg (542 lb). Attach Tooling (E) in order to remove pin (14). Do not exceed 44126 kPa (6400 psi). Remove pin (14). Repeat for the other side.
Illustration 10 g01136716
Note the location of shim (15) .
Illustration 11 g01136720
Remove bushing (16) .
Illustration 12 g01136735
Attach a suitable lifting device onto axle shaft (17). The weight of axle shaft (17) is approximately 34 kg (75 lb). Remove axle shaft (17) .
Illustration 13 g01136723
Use Tooling (F) in order to remove retaining rings (18). Remove plugs (19) .
Illustration 14 g01136749
Use a suitable press and remove U-joints (20) .
Illustration 15 g01136750
Use Tooling (G) and Tooling (H) in order to remove seal (21) and bushing (22). Repeat for the seal and the bushing in hub assembly (13). Hub assembly (13) is not shown.