FORK AS 3019753 - Caterpillar

3019753 FORK AS Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3019753
301-9753
3019753

Weight: 207 pounds 93 kg.

Buy FORK AS 3019753 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

INGERSOLL Indexable Face Mill 4" x 1.50" Bore 5H6G-40K10 3019753

$287.00

26 Oct 2020

-: -

INGERSOLL Indexable Face Mill 4" x 1.50" Bore 5H6G-40K10 3019753
Cutting Diameter: 4" || Arbor Hole Diameter: || Number of Inserts: 5 || Overall Height: 2-3/8" || Maximum Depth of Cut:

Number on catalog scheme:

Caterpillar 3019753 Parts scheme FORK AS

For full view, you need register

Information:

Illustration 9 g00950535
Illustration 10 g00950481
Press and hold the "DISPLAY MODE" keypad. Observe for any movement of the tow point cylinder (1) .
If the cylinder does not move, release the "DISPLAY MODE" keypad. Press the toggle switch upward in order to increase the valve step setting. Press the toggle switch at the rate of one click at a time.
Press and hold the "DISPLAY MODE" keypad. Observe for any movement of the tow point cylinder.
Check and adjust until the cylinder is just moving.
Use this procedure to set the raise valve step and use this procedure to set the lower valve step.Operational Check of the System's Performance
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Place the screed on the ground.
Place the screed's "Raise/Hold/Lower" switch in the Lower position. Place the engine at high idle. Verify that the hydraulic temperature is at 38 °C (100 °F).
Engage the brakes. Set the speed's dial to at least 1/2. Place the travel lever in forward. If the paver is a track-type machine, place the gear selection in "PAVE". If the paver is a machine that has rubber tires, place the gear selectors in "LOW" and in "1". Note: The previous procedure is not applicable to the APC-800C model or the BG-230 model. If the machine is an APC-800C or if the machine is an BG-230 verify the following: dial at zero, released brakes and travel lever in forward.
Illustration 11 g00950501
Place both control boxes in manual mode.
Center the cylinders of the tow points. Use thickness screws in order to bring the screed to a null position. Remove the load off the cylinders.
Illustration 12 g00950536
Place one of the sides in the slope mode.
Illustration 13 g00950504
Press and release the "NULL SETPNT" keypad. The error status display should be showing a flat line.
Illustration 14 g00950537
Press the "CONTROL MODE" keypad in order to set the control to auto mode.
Illustration 15 g00950508
Press the toggle switch upward twice and do this pressing rapidly. Release the toggle switch. The displayed value will change by