FORK (REAR) 3F0020 - Caterpillar

Installation Procedure
Table 1
Required Tooling
Tool Part Number Part Description Qty
A 369-9451 Grease -
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury or death may result from failure to adhere to the following procedures.Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system.Turn the disconnect switch OFF or disconnect the battery when changing fuel filters.
Illustration 1 g06309308
Apply Tooling (A) to the bore before installation.
Illustration 2 g06309290
Install connector (10) and valve assembly (9).
Tighten valve assembly (9) to a torque of 47 3 N m (35 2 lb ft).
Illustration 3 g06309457
Position fuel transfer pump (8) and install four bolts (7).
Illustration 4 g06309249
Install adapter assembly (6).
Illustration 5 g06309101
Install hose assembly (5).
Illustration 6 g06309073
Connect plug (1), pressure sensor (2), and hoses (3) and (4).
If, replacing pressure sensor (2) tighten to a torque of 16 3 N m (142 27 lb in).