FRAME AS-TRACK ROLLER 1198585 - Caterpillar

(1) Distance between face of flange and shoulder of pinion ... .12 .03 in.(3.0 0.7 mm) After the flange and pinion have been pushed together with a force of ... 25 to 30 ton(22.7 to 27.3 metric ton)(2) Turn sprocket four or five turns while tightening the bearing adjustment nut to a torque of ... 900 to 1200 lb. ft.(1225 to 1630 N m) Then turn the nut in the same direction until the lock can be installed in the next notch.(3) Maximum permissible amount the sprocket shaft can be bent ... .062 in.(1.57 mm) Measure at four places (every 90°) with shaft installed in the case.(4) Torque for the nut on sprocket shaft ... 500 to 600 lb. ft.(680 to 815 N m)(5) Put 9M3710 Anti-Seize Compound on threads of bolts for flange, and tighten bolts to a torque of ... 300 50 lb. ft.(410 70 N m)(6) Torque for bolts that hold bearing cage ... 100 10 lb. ft.(136 14 N m) Put oil on lip of seal for the cage before installation.(7) Torque for bolts that hold final drive case to the steering clutch case ... 100 10 lb. ft.(136 14 N m)(8) Distance between face of sprocket and the spline shoulder of the hub ... .12 .06 in.(3.0 1.5 mm) After the sprocket has been pushed on the hub with a force of ... 35 to 40 ton(31.7 to 36.2 metric ton)(9) Rubber toric seals and all surfaces in contact with them must be clean and dry at assembly. Put a thin layer of oil on the surfaces of the metal seals that are in contact just before installation. Put lubricant on all seals at assembly.(10) Tighten nut to a torque of ... 600 to 700 lb. ft.(815 to 950 N m) While shaft is being pushed into the steering clutch case with a force of ... 15 to 25 ton(13.5 to 22.7 metric ton)(11) Distance for installing shaft (from face of holder to line of separation of steering clutch case and final drive cover): 60 in. (1524 mm) gauge track ... 11.719 .062 in.(297.66 1.57 mm)74 in. (1879.6 mm) gauge track ... 18.719 .062 in.(475.46 1.57 mm)(12) (Not shown) Put 9M37100 Anti-Seize Compound on the threads of bolts that hold segments