FRAME GP 1366067 - Caterpillar

Illustration 9 g03733366
Follow setup instructions (14) .
Press the up arrow on throttle control switch (7) in order to place the engine in high idle. The engine speed should increase to 2200 rpm.
Confirm the status of the parking brake is "engaged". When the parking brake switch (5) is "engaged", LED (2) next to the parking brake switch will be illuminated.
Confirm propel lever (4) is in the NEUTRAL position.
Illustration 10 g03733397
When setup instructions are met, touch next icon (15) .
Illustration 11 g03733402
Follow calibration instructions (16) .
Illustration 12 g03733413
Turn steering wheel (17) to the STRAIGHT position.
Illustration 13 g03733409
Place Tool (A) against rims (18) .
Turn the steering wheel until the rims are parallel. Do not turn the steering wheel after the wheels are aligned.
Illustration 14 g03733416
Touch next icon (15) .
Illustration 15 g03733421
Follow calibration instructions (19) .
Turn steering wheel (17) fully counterclockwise.
Illustration 16 g03733426
Touch next icon (15) .
Illustration 17 g03733438
Follow calibration instructions (20) .
Turn steering wheel (17) fully clockwise.
Illustration 18 g03733449
Touch next icon (15) .
Illustration 19 g03733457
The display should now read "Calibration Successful" (21). Touch "OK" (13) .
Repeat Step 5 through Step 15 to calibrate the opposite operator station.
Illustration 20 g03733463
Touch home icon (22) to exit the calibration screen.
Illustration 21 g03775227
Illustration 22 g03775230
Shut off the engine. Either place machine power switch (24) in the OFF position or press and hold push to start switch (23) for 3 seconds. An LED next to the push to start switch will flash when the engine is in shutdown mode.Note: The engine may run for several minutes when placed in the shutdown mode.
If the engine was shut down using the push to start switch (23), move machine power switch (24) to the OFF position.