FRAME AS 1534992 - Caterpillar

Illustration 3 g01201230
Right armrest (C) Tilt control. (D) Lift control. (E) Auxiliary control. (G) Switch (Hydraulic lockout).Switch (G) for the hydraulic lockout valve, tilt control (C) , lift control (D) , and auxiliary control (E) are located to the right of the operator's seat. The switch (hydraulic lockout) is located in the identical place on the joystick control.ReferenceFor additional information on the switch (hydraulic lockout), refer to Systems Operation, "Switches" for the machine that is being serviced.
Illustration 4 g01201232
Implement Electronic Control (C) Tilt control. (D) Lift control. (E) Auxiliary control.Note: Illustration 4 shows a machine with an auxiliary function. Machines without an auxiliary function will not have auxiliary control lever (E) .ReferenceFor information on the implement control levers, refer to Systems Operation, "Electrohydraulic Control" for the machine that is being serviced.
Illustration 5 g01201231
Joystick Control (C) Tilt control. (D) Lift control. (E) Auxiliary control.The machine can be equipped with a joystick control. The joystick control can be equipped with either two-position sensors or three-position sensors. The sensor for the third function is controlled by the thumb wheel that is built into the joystick handle. The position sensors send the position of the joystick handle to the implement (ECM). Also, the joystick control is not equipped with electromagnets for detents. The joystick control is equipped with soft detents. For additional information about the operation of the joystick control and the soft detents, refer to the Systems Operation, "Sensors".The joystick control can be arranged in four different combinations. The joystick control can be either a two-function joystick or a three-function joystick. Also, either joystick function can be equipped with the Autodig System. If the machine is equipped with the Autodig System, refer to the Systems Operation, "Switches" for the location of the Autodig trigger switch on the joystick control.ReferenceFor additional information on the joystick control, refer to Systems Operation, "Electrohydraulic Control" for the machine that is being serviced.ReferenceFor additional information on the operation of the autodig system, refer to Systems Operation, "Aggregate Autodig" for the machine that is being serviced.
Illustration 6 g01644051
Right Side View of the Engine Compartment (37) Location of hydraulic fan pump.
Illustration 7 g01201796
Right Side View of the Engine Compartment (34) 244-1031 Control Manifold (Brake Charge, Hydraulic Fan Control) (34A) 183-7595 Solenoid Valve (Hydraulic Fan)Hydraulic fan pump (37) is located on the right side of the engine. The fan pump supplies high pressure oil to fan motor (32) . Solenoid valve (34A) controls the signal pressure to the fan pump. The fan motor rotates the fan in order to cool the hydraulic oil. The hydraulic oil cooler and oil cooler bypass valve (33) are located to the rear of the engine.
Illustration 8 g01644040
Filter Group (38) Hydraulic Oil Filter. (39) Fluid sampling valve.Hydraulic oil filter (38) is located on the right side of the machine behind the service door. The sampling valve is located on the hydraulic oil filter. The hydraulic oil filter is in the return line from the hydraulic fan system. Fluid sampling valve (39) is located above the hydraulic oil