FRAME GP-UPPER 1981700 - Caterpillar

Illustration 1 g01104928
Typical bottom view
Apply 230-6262 Sealant to four areas on the sealing surface of the oil pan. The areas are marked location (Y). The areas are at the corners of the oil pan in the following locations:
Connecting joint of the front housing and the front of the cylinder block
Connecting joint of the flywheel housing and the rear of the cylinder blockMake sure that all surfaces are clean and that all surfaces are free of oil and debris. The sealant must be applied with a consistent bead of the sealant that is 5 mm (0.2 inch) diameter in cross section on the block. The joint must be assembled within 5 minutes of the application of the sealant.Use the following procedure to tighten the bolts for the oil pan.Tighten the four bolts (X) to the following torque. ... 28 7 N m (21 5 lb ft)Start with bolt (Z) and tighten all the remaining bolts in a counterclockwise sequence. Tighten the bolts to the following torque. ... 28 7 N m (21 5 lb ft)Start again with bolt (Z) and tighten all bolts in a counterclockwise sequence.Tighten the bolts to the following torque. ... 31 3 N m (23 2 lb ft)Tighten the oil drain plug to the following torque. ... 40 5 N m (30 4 lb ft)