FRAME GP-TELESCOPING RECOIL 2230656 - Caterpillar

Illustration 11 g02262518
Press the left key or the right key to toggle between checked and unchecked. Press the up key and the down key to move between the responses.Some responses are fixed and cannot be disabled. For those responses, a lock will be displayed instead of a checkbox.Set Points on Cat ET
EMCP 4 set points can be configured using Cat ET.If a value is changed from the EMCP display, Cat ET will not refresh the set point automatically. Press the "Config Tool" icon to refresh the list.Categories of set points are listed along the left pane. Clicking one of the set points will bring up that list in the right pane.EMCP 4.2 have different numbers of set points. The categories shown here match the categories in Cat ET version 2010C. Older versions may have less, and newer versions may have more.Note: Any set point with a value given as "Unavailable" is not applicable to that level of EMCP 4.Set Point Categories
The following list is the categories of set points as found in the left pane of Cat ET:Analog Inputs - Set points related to analog inputs.Automatic Start/Stop - Set points related to starting and stopping the generator set, as well as engine configuration.Battery Voltage Monitor - Set points related to monitoring battery voltage from the battery power input to the EMCP 4.Crank Attempt/Sucessful Start Counter - Set point related to crank/start counters.RS-485 SCADA Data Link (EMCP 4.2 only) - Set points related to SCADA (Modbus) data link communications.Digital Inputs - Set points related to digital inputs.Digital Outputs - Set points related to the polarity of digital outputs.Engine Coolant Temperature Monitor - Set points related to monitoring engine coolant temperature.Engine Oil Pressure Monitor - Set points related to monitoring engine oil pressure.Engine Speed Monitor - Set points related to monitoring engine speed using the Magnetic Pick-Up (MPU) input.Enhanced Engine Monitor - Set points that are to related engine cylinder temperature monitoring via the optional thermocouple module. Applies to EMCP 4.2 only.Enhanced Generator Monitor - Set points related to generator bearing and winding temperature monitoring via the optional RTD module. Applies to EMCP 4.2 only.Event Response Configuration - Diagnostic Events - Set points used to configure the EMCP 4 response to diagnostic events.Event Response Configuration - Engine Protection Events - Set points used to configure the EMCP 4 response to engine protection events.Event Response Configuration - Generator Protection Events - Set points used to configure the EMCP 4 response to generator protection events.Event Response Configuration - Other System Events - Set points used to configure the EMCP 4 response to events that do not fit into the category of diagnostics, engine protection, or generator protection.Event Response Configuration - Custom Events - Set points used to configure the EMCP 4 response to custom events.Event System (EMCP 4.2 ONLY) - Set points used to configure the engine running conditions for the engine run lamp on the RS-485 annunciator.Fuel Transfer - Set points related to fuel transfer feature.Generator AC Monitor - Set points related