FRAME AS 2483904 - Caterpillar

To prevent personal injury, install guards over all exposed rotating parts.Stop engine before adjusting or repairing engine or driven equipment.Do not wear loose clothing whenever working around engines or machinery.To prevent hearing damage, wear ear protective devices if working inside an enclosed engine room with engine running.Wear protective glasses, clothing, hat, respirator or other protective items when necessary.When using pressure air, wear protective face shield and clothing. Use 30 PSI (205 kPa) maximum air for cleaning purposes.Always inspect cooling system with engine stopped.If equipped with jacket water cooling system, remove filler cap slowly to relieve pressure. Steam may cause personal injury.Cooling system inhibitor contains alkali, avoid contact with skin and eyes to prevent personal injury.Do not smoke when observing battery electrolyte level. Batteries give off flammable fumes.Be sure engine room is properly ventilated.Do not allow electrolyte solution to contact skin or eyes. Electrolyte solution is an acid.An overly rich fuel mixture can cause combustion in the exhaust system.Do not attempt repairs you do not understand. Follow instructions.Replace or repair broken or damaged servicing equipment. Use proper tools.Remove all tools, electrical cords and other loose items from the engine before starting.Wipe up spilled oil or coolant.Provide adequate and safe waste oil disposal.Store oily rags in fireproof containers. DO NOT leave rags on engine.Never store flammable fluids near the engine.All electrical equipment must be grounded according to local building or safety codes.Check all electrical connections periodically for tightness and insulation.Insulate all electrical connections and disconnected wires.Disconnect and tape the battery ground lead before working on an engine to prevent accidental starting. Be sure an automatic start-stop system, if equipped, cannot operate and start the engine while working on it.Never start an engine with the governor linkage disconnected.When starting an engine after repair, make provisions for shutting off air supply, to stop engine, in case there is an overspeed on start up.Check piping periodically for gas leaks.All gas lines and valves must meet local codes.Be sure gas has not entered the exhaust manifold before attempting to start.