FRAME GP-TRACK ROLLER 2953220 - Caterpillar

Typical Example(2) Torque for ten screws ... 8 3 N m (6 2 lb ft)(3) Torque for two screws ... 8 3 N m (6 2 lb ft)(4) Torque for three screws ... 8 3 N m (6 2 lb ft)(5) Torque for four bolts ... 55 7 N m (41 5 lb ft)(7) Torque for nuts ... 4 1 N m (3 1 lb ft)(9) Torque for two bolts ... 8 3 N m (6 2 lb ft)Dimension W ... 10 2 mm (.4 .08 in) Use 4N3329 Washer as required to set 1.5 dimension Z as shown in Section C-C. Use 9V1312 Bearing as required to set 2.5 dimension Y as shown in Detail B. Use a minimum of one bearing between each part. Use 8H9190 Shim as required. Adjustment Procedure For Kickout Solenoids1. Turn key switch to ON position.2. Make sure lift kickout and implement positioner are correctly located.3. Raise and tilt bucket or implement to the limit of its travel.4. Turn key switch to OFF position.5. With control levers in the HOLD position, measure distance X with all slack removed from linkages. Distance X must be 1 1 mm (.04 .04 in) between roller (8) and cam surface (6). If not, loosen locknut (10) on threaded rod 12) and turn solenoid plunger (11) until distance X is correct.6. Turn key switch to ON position.7. Do Steps 2 through 5 again to check operation and adjustments of Kickout solenoids (1).8. Tighten locknut (10).7. Do Steps 2 through 5 again to check operation and adjustments of Kickout solenoids (1).8. Tighten locknut (10).