FRAME AS 3233531 - Caterpillar

Illustration 4 g06074581
Remove bolt (10).
Disconnect harness assembly (13).
Disconnect three hose assemblies (11) from valve block (12).
Remove the bolts and valve block (12).
Illustration 5 g06074662
Remove the bolts, the washers, and door support (14).
Illustration 6 g06074706
Remove the nut, the washer, and cable assembly (15) from the alternator.
Disconnect harness assemblies (18) and (19).
Loosen clamp (16).
Remove nut (17), the washer, the P-clip, and tube (21).
Loosen clamp (20) and remove exhaust tube (22).
Illustration 7 g06074782
Disconnect harness assembly (23).
Illustration 8 g06074802
Remove bolt (24) and grounding straps (25).
Illustration 9 g06074814
Remove the nuts, the washers, and cable assemblies (26), (27), and (28).
Remove bolt (29), the plate assembly, and the clamps. Reposition cable assemblies (26), (27), and (28) out of the way.
Illustration 10 g06074842
Loosen the clamp and remove hose (30).
Remove cable straps (34).
Disconnect hose assemblies (31) and (33).
Disconnect two hose assemblies (35) from the gear pump.
Remove the bolts and the washers that secure engine oil filter assembly (32) to the frame. Use cable straps to secure engine oil filter assembly (32) to the engine.
Illustration 11 g06074884
Remove the three bolts and plate assembly (36). Remove the plate assembly on the other side of the auger system.
Illustration 12 g06074895
Illustration 13 g06074900
Illustration 14 g06074906
Attach Tool (A), Tool (B), and a suitable lifting device to engine (37) and the pump drive generator. The weight of engine (37) and the pump drive generator is approximately 862 kg (1900 lb).
Remove two bolts (38), two bolts (39), the washers, and the nuts. Remove engine (37) and the pump drive generator.Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 6V-3145 Load Leveler Gp 1
B 138-7574 Link Brackets 2
C 386-6031 Lever Puller Hoist Gp 1
D - Loctite RTV Clear Silicone Sealant 1
Install engine (37) and the pump drive generator in reverse order of removal.
Apply a 3 1 mm (0.12 0.04 inch) bead of Tool (D) to plate assembly (6) and cover plate (3).End By:
Install the muffler. Refer to Disassembly and Assembly, Muffler - Remove and Install for the correct procedure.
Install the right piston pump (propel). Refer to Disassembly and Assembly, Piston Pump Right Propel) - Remove and Install for the correct procedure.
Install the left piston pump (propel). Refer to Disassembly and Assembly, Piston Pump Right Propel) - Remove and Install for the correct procedure.
Install the cooling package. Refer to Disassembly and Assembly, Radiator, Hydraulic Oil Cooler, and Fuel Cooler - Remove and Install for the correct procedure.